9300 Cal Controls

Operating Manual CAL Controls Temperature Controllers CAL 3300 and 9300 Autotune Temperature Controllers CAL Controls Ltd Bury Mead Road, Hitchin, Herts, SG5 1RT. UK Tel: + 44 (0)1462-436161 Fax: + 44 (0)1462-451801 email: support cal-controls.co.uk Index Safety and W arranty INDEX SAFETY AND WARRANTY INFORMATION SAFETY & WARRANTY A1 SECOND SETPOINT (SP2) 12 INSTALLATION ULTIMATE SAFETY ALARMS FUNCTIONS MENU A3 SP2 as an alarm 12 QUICK START SP2 subsidiary mode 13 Designed for use: Do not use SP2 as the sole alarm where personal injury or Quick Start Set-up 1a SP2 as a proportional output 13 UL873 - only in products where the acceptability is damage may be caused by equipment failure. INTRODUCTION 2 SP2 alarm condition table 13 The controllers 2 SP2 alarm annunciator 13 determined by Underwriters Laboratories Inc. OVERVIEW 3 ERROR MESSAGES 14 EN61010-1 / CSA 22.2 No 1010.1 - 92 WARRANTY Installation 3 Recommendations 14 To offer a minimum of Basic Insulation only. Set-up 3 Autotune data in tECH 14 Suitable for installation within Catagory II and III and Pollution CAL Controls warrant this product free from defect in Autotune 3 IMPROVING CONTROL ACCURACY 15 Degree 2. workmanship and materials for three (3) years from date of Cycle-time 4 Using ChEK accuracy monitor 15 SET-UP 5 FUNCTION LIST 16 purchase. Power-up 5 Level 1 16 SEE ELECTRICAL INSTALLATION P29 & P30 1 Should the unit malfunction, return it to the factory. If Select input sensor 5 Level 2 18 defective it will be repaired or replaced at no charge. Select display units 5 Level 3 19 It is the responsibility of the installation engineer to ensure 2 There are no user-servisable parts in this unit. This Allocate output device 5 Level 4 21 this equipment is installed as specified in this manual and is waranty is void if the unit shows evidence of being Enter initial configuration 5 OUTPUT OPTIONS 22 Set main setpoint 5 ADVANCED SETTINGS 23 in compliance with appropriate wiring regulations. tampered with or subjected to excessive heat, moisture, MENU NAVIGATION 6 Heat Cool strategy 23 corrosion or other misuse. Using program mode 6 Calibration to other instrument 24 CONFIGURATION 3 Components which wear, or damage with misuse, are AUTOTUNE 7 Linear input calibration 25 excluded e.g. relays. Tune program 7 MECHANICAL INSTALLATION 27 All functions are front selectable, it is the responsibility of 4 CAL Controls shall not be responsible for any damage or Tune at setpoint program 8 DIN panel cut-outs 27 PROPORTIONAL CYCLE-TIME 9 Minimum spacing 27 the installing engineer to ensure that the configuration is losses however caused, which may be experienced as a Cycle-time selection methods 9 Mounting 28 safe. Use the program lock to protect critical functions from result of the installation or use of this product. Cycle-time recommendations 9 ELECTRICAL INSTALLATION 29 tampering. CAL Controls liability for any breach of this agreement shall Autotune calculated cycle-time 9 General requirements 29 not exceed the purchase price paid E. & O.E. PROGRAMMER 11 Connection diagrams 30 Ramp-Soak 11 INPUT/SENSOR SELECTION 31 SPECIFICATION 32 A1 A2