CBRPF-CAR-C CamdenBoss

rspa By err ip STYLE ENCLOSURES Fitting of the PCB, Light Pipe and Pi-Face Digital Assembly universal e nclosures Light Pipe Assembly hand held cases 1. Place your Pi-Face Digital top and base onto a steady surface. 2. Peel off the protective film on the light pipes. he y 3. Apply two drops of glue onto the recess. (We recommend using Everbuild stick 2 All Purpose Superglue) duty enclosures 4. Ensuring that the light pipe is in the correct orientation as shown, place into the recess and hold for five seconds ensuring that the light pipes are perpendicular to the enclosure top. din r ail Boxes 2. 1. i nterce supports control tiosns 3. 4. diecast & mael t Boxes d esktop & i nstrumen t cases p otting Boxes PCB Assembly 5. Place your Pi-Face Digital enclosure base onto a steady surface. 19 e nclosures 6. Tilting your Pi-Face Digital at 45 angle align the audio and RCA video ports with the machined holes in the base and push until the PCB clips into the PCB groove. 19 7. Push the opposite side of the PCB down so that it clips into the second PCB groove in the base. s u Brac c ustom 6. 7. sized enclosures c ustom s ervices +44 (0)1638 716101 2 info camdenboss.com Ver 1.0 We operate a constant improvement policy, our products are subject to change without notice. www.camdenboss.com ELECTRONICS & ENCLOSURES ks ta fa avrspa By err ip STYLE ENCLOSURES universal e nclosures Pi-Face Digital Enclosure Assembly hand 8. Place you Raspberry Pi-Face Digital Enclosure on a steady surface. held cases 9. Place your four supplied actuators into the locations shown below. (Ensure correct orientation) 9. he y 8. duty enclosures din r ail Boxes i nterce supports control tiosns 10. Hold the base upside down, in one hand (thumb on the audio connector, fingers over the HDMI connector) Align the USB connector with USB cut-out and clip over the USB and LAN connectors. Then clip the opposite diecast end of the top onto the base. & mael t Boxes 10. d esktop & i nstrument cases p otting Boxes 19 e nclosures 19 s u Brac 11. Peel off the protective film on both the top and base of your enclosure. Push the supplied feet into place if required. c usto m sized 11. enclosures c ustom s ervices +44 (0)1638 716101 info camdenboss.com We operate a constant improvement policy, Ver 1.0 Iss 1 www.camdenboss.com our products are subject to change without notice. ELECTRONICS & ENCLOSURES ks ta fa av