NOW PART OF LW-Series Wiper / Washer Controls PRODUCT WEBPAGE request sample, configure part The LW-Series Electronic Wiper Washer Control combines two switches into one self-contained unit allowing effortless control of both wash and wipe functions from a singular location. A variety of features and options including, Continuous low and high speed wiper positions, Six intermittent delay intervals ranging from 3-18 seconds, Push-to-wash button and an LED Night- light indicator combine to provide the flexibility to meet most any Cab design. 2 1-8 14-28 Poles Amps VDC Typical Applications On/Off-Highway Equipment Agricultural Equipment Construction Equipment www.carlingtech.com 860.793.9281 sales carlingtech.comTech Specs Electrical Physical Contact Rating 1 relay Illumination LED, rated 100,000 hours 1/2 life 8 amps, 14VDC Cover Acetate 4 amps, 28VDC 2 relays Washer Actuator Silicone 1 amps, 14VDC 1 amps, 28VDC Toggle Actuator Nylon 6/6 glass filled Terminals .187 (7.4mm) Quick Connect Bracket Nylon 6/6 terminations standard. Connector Nylon 6/6 rated 85C polarized Protection Reverse polarity protection Over voltage protection Washer Function Momentary Cold cranking protection according to SAE J1455, Sections. Toggle Function Maintained Intermittent 4.11.1.1.1 and 4.11.1.2.1 Operation Momentary Transient voltage protection which includes load dump and Weight 44 grams inductive switching according to SAE J1455, sec. 4.11.2.2 Electrostatic discharge protection according to SAE J1455 Sec. 4.11.2.2.5.1 (Discharge a 150 pf Environmental capacitor that has been charged Operating Temp. -25C to +85C to a potential of 15kV through 150 Ohm resistor.) Temperature Cycle According to SAE J1455, Meets all other EMI/EMC Sec. 4.1.3.1 (See Figure below) requirements for class C trucks. T 85C Mechanical Mechanical Sinusoidal Vibration: 10-55-10 Hz, 0.06 DA, one minute-cycle, three hours/axis amb Random Vibration: Three hours/ -40C axis, three mutually perpendicular axes with a test level 4 16 24 hour 4Gs. Thermal Shock According to SAE J1455, Frequency Amplitude Sec. 4.1.3.2 (See Figure below) 5Hz 0.16 G2/Hz 100Hz 0.16 G2/Hz T 500Hz -3dB/octave roll-off 85 C Tests were conducted according to SAE J1455, Sec 5.7 and Sec. 4.9.4. Shock: MIL-STD-202G Method 213B, Test Condition K, 30Gs, 11 ms. Endurance According to SAE J2349, March 97 -40 C for windshield washer switch for 2 Trucks, Buses and Multipurpose 0 4 6 8 10 12 14 16 18 hour Vehicles (20,000 cycle minimum). Humidity According to SAE J1455, Sec. 4.2.3 (30 cycles for 8 hrs. with maximum temperature of 85C and 95% relative humidity. Dust Bombardment According to SAE J1455, Sec. 4.7.3 (with dust concentration of 0.88gm/m for 24 hours.) Salt Spray MIL-STD-202G, Method 101D for 96 hours. *Manufacturer reserves the right to change product specification without prior notice. 2.