Photoelectrics Through-beam, Transistor Output Type PA12BNT20.. Elevators, Escalators and Entrance control Range 20 m ESPE-Type 2, PL C. Modulated, infrared light Supply voltage: 10 to 30 VDC Output: 100 mA, NPN or PNP type Make or break switching Protection: reverse polarity, short circuit, transients Cable versions with or without connector Emitter mute and power adjustment CE, UL325 and UL508 approved Product Description Ordering Key PA12BNT20NO-C2 Type The PA12BNT. is a through known for its high long-term Housing style beam sensor set special- reliability. The emitter has Housing size ly designed for elevators, a mute input to turn it off Housing material escalators, entrance control for evaluation of the sensor Neutral to meet the requirements in function. Detection principle the door market. The hous- Available in 10-30 VDC Sensing distance ing is very robust and is version. Output type Output configuration Connection type Cable connector Type Selection Housing Range Connector Ordering no. Ordering no. Ordering no. Ordering no. Ordering no. diameter S Receiver Receiver Receiver Receiver Emitter n NPN, NO NPN, NC PNP, NO PNP, NC M12 20 m NO PA12BNT20NO PA12BNT20NC PA12BNT20PO PA12BNT20PC PA12BNT20 M12 20 m YES PA12BNT20NO-C2 PA12BNT20NC-C2 PA12BNT20PO-C2 PA12BNT20PC-C2 PA12BNT20-C2 Note: Please order emitter and receiver separately Specifications Emitter Rated operational volt. (U ) 10 to 30 VDC Light source LED, 860 nm B Ripple (U ) 10% Light type Infrared, modulated rrp Supply current 20 mA Light spot 1580 mm 12 m Protection Reverse polarity, transients Emitter angle 3.8 12 m Power ON delay (tv) 100 ms Power adjustment Rx ~ 3 k -10 k 4...24 m in 19 steps Control input Normal oper. > 1.5 VDC Mute < 1.2 VDC Specifications are subject to change without notice ( 20.04.2017) 1 PA12BNT20 Specifications Receiver Rated operating dist. (S ) 20 m Protection Short-circuit, reverse pola- n rity, transients Blind zone None Utility category DC12 Control of resistive loads Temperature drift 0.4%/C and solid state loads with Hysteresis (H) 3 - 20% optical insulation Rated operational volt. (U ) 10 to 30 VDC (ripple included) B DC13 Control of electromagnets Ripple (U ) 10% rrp Ambient light > 20.000 Lux (EN60947-5-2) No load supply current (I ) 16 mA o Detection angle 2.9 12 m Output current Operating frequency (f) 100 Hz Continuous (I ) 100 mA e Response time OFF-ON (t ) 6.5 ms ON Short-time (I) 100 mA, ON-OFF (t ) 3.5 ms OFF (max. load capacity 100 nF) Power ON delay (t ) 100 ms v Minimum operational current (I ) 0.5 mA m Output function OFF-state current (I ) 100 A r NPN or PNP Make or break (NO or NC) Voltage drop (U ) 1.6 VDC 100 mA d General Specifications Environment Electrical fast transients/burst Overvoltage category IIl (IEC 60664/60664A, (EN 61000-4-4) 4 kV 60947-1) Surge (EN 61000-4-5) Pollution degree 3 (IEC 60664/60664A, Power-supply > 1 kV (with 500 ) 60947-1) Sensor output > 1 kV (with 500 ) Degree of protection IP67 (IEC 60529 EN60947-1) Wire conducted disturbances 1, 2, 3, 4, 6, 12, 13 (NEMA (EN 61000-4-6) > 10 Vrms types) Power-frequency magnetic Temperature fields (EN 61000-4-8) Operating -20 to +50C (-4 to +122F) Continous > 30 A/m, 38 tesla Storage -25 to +80C (-13 to +176F) Short-time > 300 A/m, 380 tesla Rated insulation voltage 75 VDC Vibration (IEC 60068-2-6) 10 to 150 Hz, 1 mm / 15 g Dielectric test voltage 500 Vac rms (EN60947-1) Shock (IEC 60068-2-27) 30 G / 11 ms, 6 pos, 6 neg Rated impulse withstand test 800 V (1.2 / 50 s) (EN60947-1) per axis ESPE Type 2 Free fall (IEC 60068-2-31) 2 times from 1 m -8 PFH 6 x 10 failure per hour 100 times from 0.5 m d (worst case SRP for CS) Pig-tail connector (-C2) 3-pol micro MATE-N-LOK Diagnostic coverage 99 % (EN13849-1: 2008) Series, AMP/TE Performance level C (EN13849-1: 2008) Housing material Body M12-Stainless Steel MTTF (worst case full sensor) 345 Years d Front PC black (worst case full receiver) EN ISO 13849-1, SN 29500 Connection 412 Years Cable PVC, Emitter: grey / (worst case full emitter) Receiver: black, 2 EN ISO 13849-1, SN 29500 5 m, 3 x 0.14 mm , 2.9 mm Electrostatic discharge Weight (EN61000-4-2) Emitter 80 g Contact discharge > 12 kV Receiver 80 g Air discharge > 8 kV CE-marking EN12445, EN12453, Radiated RF electromagnetic EN12978, EN 60947-5-2 fields (EN 61000-4-3) > 10 V/m UL-Approval UL325 UL508, CSA-C22.2 No.247 2 Specifications are subject to change without notice ( 20.04.2017)