Photoelectrics Through-beam Type PD30CNT15....SA Miniature sensor range Range: 15 m Sensitivity adjustment by potentiometer Modulated, infrared light 850 nm Supply voltage: 10 to 30 VDC Output: 100 mA, NPN or PNP preset Make and break switching function LED indication for output, stability and power ON Protection: Short-circuit, reverse polarity and transients Cable and plug versions Excellent EMC performance Product Description Ordering Key PD30CNT15NAM5SA The PD30CNT15 sensor The potentiometer function Type family comes in a compact for adjustment of the sen- Housing style 10 x 30 x 20 mm reinforced sitivity makes the sensors Housing size PMMA/ABS housing. highly flexible. The output Housing material The sensors are useful in type is preset (NPN or PNP), Housing length applications where high-ac- and the output switching Detection principle curacy detection as well as function is NO and NC out- Sensing distance small size is required. put. Output type Compact housing and high Output configuration power LED for excellent Connection type performance-size ratio. Sensitivity adjustment Type Selection Housing Range Connection Ordering no. Ordering no. Ordering no. W x H x D S Emitter NPN PNP n Make and break switching Make and break switching 10 x 30 x 20 mm 15 m Cable PD 30 CNT 15 PD 30 CNT 15 NASA PD 30 CNT 15 PASA 10 x 30 x 20 mm 15 m Plug PD 30 CNT 15 M5 PD 30 CNT 15 NAM5SA PD 30 CNT 15 PAM5SA Note: Emitter, receiver and connector to be ordered separately Specifications Receiver EN 60947-5-2 Rated operating distance (S ) OFF-state current (I ) 100 A n r PD30CNT emitter 15 m Voltage drop (U ) 2 VDC I max d e Adjustment range 3 to 15 m Protection Short-circuit, reverse polarity Blind zone and transients PD30CNT emitter None Ambient light 10,000 lux Sensitivity Operating frequency (f) 500 Hz Electrical adjustment 210 Response time Mechanical adjustment 240 OFF-ON (t ) 1 ms ON Temperature drift 0.2%/C ON-OFF (t ) 1 ms OFF Hysteresis (H) 5% to 20% Power ON delay (t ) 200 ms v Rated operational volt. (U ) 10 to 30 VDC B Output function (ripple included) Open collector NPN or PNP by sensor type Ripple (U ) 10% rpp Output switching function N.O. and N.C. Output current Indication Continuous (I ) 100 mA e Output ON LED, yellow Short-time (I) 100 mA Signal stability ON and (max. load capacity 100 nF) Power ON LED, green. See curve for No load supply current (I ) 20 mA U max o B condition of stability Minimum operational current (I ) 0.5 mA m Specifications are subject to change without notice (13.06.2016) 1 PD30CNT15....SA Specifications Emitter EN 60947-5-2 Rated operational volt. (U ) 10 to 30 VDC Light spot 110 mm 1.5 meters B (ripple included) distance Ripple (U ) 10% rpp Power ON delay (t ) 200 ms v No load supply current (I ) 25 mA U max o B Protection Reverse polarity and transients Light source LED, 850 nm Indication Light type Infrared, modulated Power ON LED, green Emitter angle 2 half sensing distance General Specifications EN 60947-5-2 Environment Housing material Installation category III (IEC 60664/60664A Body ABS Light Grey 60947-1) Frontglas PMMA Red Pollution degree 3 (IEC 60664/60664A Trimmer shaft POM Dark Grey 60947-1) Connection Degree of protection IP 67 (IEC 60529 60947-1) Cable PVC, black, 2 m 2 Ambient temperature 4 x 0.14 mm , = 3.3 mm Operating -25 to +60C (-13 to +140F) Plug M8, 4-pin (CON. 54-series) Storage -40 to +70C (-40 to +158F) Weight Vibration 10 to 150 Hz, 1.0 mm/15 G Cable version 50 g (IEC 60068-2-6) Plug version 20 g Shock 30 g / 11ms, 3 pos, 3 neg CE-marking Yes per axis Approvals cULus (UL508 + CSA) (IEC 60068-2-6, 60068-2-32) Rated insulation voltage 500 VAC (rms) Operation Diagram Tv = Power ON delay ON Power supply OFF Present Target Not Present Tv ON Break Output (N.C.) OFF Tv ON Make Output (N.O.) OFF Signal Stability Indication Wiring Diagrams 1BN NPN Excess Gain 2WH Operation level x 1.25 1.25 4BK Operation level 1.0 Operation level x 0.75 0.75 3BU 1BN PNP Time Green LED ON 4BK Yellow LED ON 2WH 3BU 2 Specifications are subject to change without notice (13.06.2016)