Photoelectrics Retro-reflective, Polarized Type PH18CNP..., DC Miniature sensor range Range: 5 m Sensitivity adjustment by potentiometer Modulated, red light 625 nm Supply voltage: 10 to 30 VDC Output: 100 mA, NPN or PNP, N.O & N.C. Degree of protection: IP67, IP69K LED indication for output, stability and power ON Protection: reverse polarity, short circuit and transients Cable, plug and pigtail versions Excellent EMC performance Product Description Ordering Key PH18CNP50PAM1SA The PH18CNP... is part of a Compact housing and high Type family of inexpensive general power LED for excellent Housing style square purpose retro-reflective sen - performance-size ratio. Housing size sors in industrial standard 18 The potentiometer used for Housing material mm cylindrical and square adjustment of the sensitivi- Housing type neutral ABS housing. ty makes the sensors highly Detection principle The sensors are useful in flexible. The output type is Sensing distance applications where high-ac- NPN or PNP and the output Output type curacy detection as well as switching function is NO and Output configuration small size is required. NC. Connection type Sensitive adjustment Type Selection Housing style Range Connection Ordering no. Ordering no. S NPN PNP n Make & break switching Make & break switching M18 Square type 5.0 m Cable PH 18 CNP 50 NASA PH 18 CNP 50 PASA M18 Square type 5.0 m Plug PH 18 CNP 50 NAM1SA PH 18 CNP 50 PAM1SA M18 Square type 5.0 m Pigtail M12 PH 18 CNP 50 NAT1SA PH 18 CNP 50 PAT1SA Specifications according to EN60947-5-2 Rated operating distance (S ) Up to 5.0 m, Voltage drop (U ) 2.0 VDC 100 mA n d Reference target: ER4 Protection Short-circuit, reverse reflector 80 mm polarity and transients Blind zone 50 mm Sn max. Light source InGaAIP, LED, 625 nm Sensitivity control Adjustable by potentiometer Light type Red, modulated Electrical adjustment 210 Sensing angle 2 Mecanical adjustment 240 Ambient light 30.000 lux Adjustable distance to target 50-500 cm Incandescent lamp Temperature drift 0.2%/C Light spot Diameter 150 mm 2.5 m Hysteresis (H) Operating frequency 500 Hz (differential travel) 20% Response time Rated operational volt. (U ) 10 to 30 VDC B OFF-ON (t ) 1.0 ms ON (ripple included) ON-OFF (t ) 1.0 ms OFF Ripple (U ) 10% rpp Power ON delay (t ) 100 ms v Output current Output function Continuous (I ) 100 mA e Type NPN or PNP Short-time (I) 100 mA (max. load capacity 100 nF) Switching function NO and NC No load supply current (I ) 25 mA 24 VDC o Indication Output ON LED, yellow Minimum operational current (I ) 0.5 mA m Signal stability and power ON LED, green OFF-state current (I ) 100 A r Specifications are subject to change without notice (20.05.2021) 1 PH18CNP... Specifications (cont.) Cable gland POM, Black Environment Trimmer shaft POM, Dark Grey Installation category III (IEC 60664/60664A Locknuts PP, black 60947-1) Mounting bracket PPA, black Pollution degree 3 (IEC 60664/60664A 60947-1) Connection Degree of protection IP 67, IP 69K* Cable PVC, grey, 2 m 2 4 x 0.25 mm , = 4.5 mm Ambient temperature Plug M12, 4-pin Operating -25 to +60C (-13 to +140F) (CONB14NF-series) Storage -40 to +70C (-40 to +158F) Pigtail PUR, grey, 30 cm Vibration 10 to 150 Hz, 1.0 mm/15 g 2 4 x 0.25 mm , = 4.5 mm (IEC 60068-2-6) M12, 4-pin Shock 30 g / 11ms, 3 pos, 3 neg (CONB14NF-series) per axis Weight With cable: 85 g (IEC 60068-2-6, 60068-2-32) With pigtail: 40 g Rated insulation voltage 500 VAC (rms) With plug: 25 g IEC protection class III CE-marking Yes Housing material Approvals cULus (UL508) Body ABS, grey supply class 2 Backpart PC-Transparent Front material PMMA, red 90 * The IP69K test according to DIN 40050-9 for high-pressure, high-temperature wash-down applications. The sensor must not only be dust tight (IP6X), but also able to withstand high-pressure and steam clea- 60 ning. The sensor is exposed to high pressure water from a spray nozzle that is fed with 80C water at 8000 10000 KPa (80100bar) and a flow rate of 146L/min. The nozzle is held 100 150 mm from the sensor at angles of 0, 30, 60 and 90 for 30s each. The test device sits on a turntable that rotates with 30 a speed of 5 times per minute. The sensor must not suffer any damaging effects from the high pressure water in appearance and function. 0 Operation Diagram Operation Diagram tv = Power ON delay ON Power supply OFF Present Target Not Present Present Object Not Present Tv ON Break Output (N.C.) OFF Tv ON Make Output (N.O.) OFF Wiring Diagrams NPN PNP V V 1 BN 1 BN 4 BK 2 WH 2 WH 4 BK 3 BU 3 BU V GND V GND 2 Specifications are subject to change without notice (20.05.2021)