Ultrasonic Thru Scan, NPN Output Type UC 80 CNS 40 NO 80 x 80 x 43 mm polyester housing Sensing distance: 40-4000 mm Retro-reflective Teach-in adjustment Output: NPN Power supply: 19 to 30 VDC 8 beam angle Alignment LED Protection: Short-circuit, reverse polarity, transients Protection degree IP 67 Product Description Ordering Key UC 80 CNS 40 NO A diffuse ultrasonic sensor and high noise immunity. Due Ultrasonic sensor with a sensing of 400-4000 to use of microprocessor con- Housing style mm with a NPN transistor trol the digital filtering make Housing size output. Both the housing and the sensor very immune Housing material the sensor transducer are against most electromagnetic Housing length designed for tough environ- interferences and enables Detection principle ment. A high carrier frequency synchronisation in an easy Sensing distance secures a precise measuring way. Output type Output configuration Type Selection Housing Connection Rated operating Ordering no. dimensions dist. (S ) Thru Scan, NPN n 80 x 80 x 43 mm Screw terminals 400-4000 mm UC 80 CNS 40 NO Specifications Rated operational volt. (U ) 19 to 30 VDC Rated operating distance 400-4000 mm e (ripple included) Carrier frequency 120 kHz Ripple 10% Beam angle 8 No-load supply current (I ) 50 mA o Ambient temperature Protection Short-circuit, transients and Operating 0 to +70C (32 to +158F) reverse polarity Storage -20 to +80C (-4 to +176F) Rated insulation voltage > 1 kV Degree of protection IP 67 (Nema 1, 3, 4, 6, 13) Output Transistor, NPN Housing material Polyester PBTP Resolution min. 20 mm Dimensions 80 x 80 x 43 mm Linearity 0.5% Connection Screw terminals, PG 13.5 Repeatabilty 0.5% Weight 250 g Temperature deviation 1% CE-marking Yes Temperature compensation Yes Indications Alignment LED, green Output status LED, yellow Specifications are subject to change without notice (30.10.01) 1UC 80 CNS 40 NO Wiring Diagram Dimensions 3 GND Blue 4 Switching output Black 2 Teach-in Pink 1 +24 VDC Brown Detection Range Function Diagram Sensor Reference target +40 -40 Output mm 400 mm 4000 Guaranteed detection of a target 100 x 100 mm Distance Possible detection of a large target Installation Hints To avoid interference from inductive voltage/ Relief of cable strain Protection of the sensing face Switch mounted on mobile carrier current peaks, separate the prox. switch power cables from any other power cables, e.g. motor, contactor or solenoid cables Incorrect Correct The cable should not be pulled A proximity switch should not serve as Any repetitive flexing of the mechanical stop cable should be avoided 2 Specifications are subject to change without notice (30.10.01)