EVMB-ICNR Connect One

EVMB-ICNR Quick experience guide Dear Customer, Thanks for choosing ConnectOne for your IoT experience. The EVMB-ICNR is an iChipNet Ready evaluation kit which will allow you to experience Connect Ones iChipNet, a complete IoT end to end solution. The WiFi module on the EVMB-ICNR has been programmed with special firmware and internal host website specifically designed to allow you to control two Programmable Input Output Controls (PIOCs) located on the EVMB-ICNR board. Using the internal host website you will be able to control the direction of the PIOC (input or Output), force changes on the EVMB-ICNR board while in output state, and receive status of the PIOC while in input state. The purpose of this quick guide is to allow you to access the EVMB-ICNR internal host website using Connect Ones Device Connectivity Server (DCS) which is a device management application for remote device access. It is recommended that you be familiar with the basic EVMB User Manual located in Connect Ones web site under the Products tab (2. iChipNet Ready Evaluation Board setup Using the supplied power supply, hook up the EVMB-ICNR to the power and turn it on. The EVMM-ICNR is set up as a WiFi Access Point by default. A. On your computers WiFi network connection list search for the EVMB-ICNR Access Point B. Once connected to the EVMB-ICNR access point, browse to: 10.0.0.1 3. Setting up the EVMB-ICNR for internet connection Using your local access point connection credential, the EVMB-ICNR will connect to the internet and register itself to the Device Connectivity Server (DCS). A. In the WiFi Configuration section please enter the SSID of your local router, the Security type and the Password Phrase B. In the Device Connectivity Server section, please enter the account name you created in section 1 above and give your EVMB-ICNR a name. C. Click submit. At this stage, the unit will reset itself into client mode and will use your local access point for Internet connectivity. Upon connecting, the EVMB-ICNR will automatically register itself in the Device Connectivity Server under the account name you have created in section 1 and will use the name you have set in section 3-B. 4. Remote device access Using the Device Connectivity Server for remote device access A. Browse to www.ichipnet.com/managernew B. Enter your account name and password and click Log In The Device Connectivity Server will access your account and will show the registered device. Clicking the icon under Host Site will access the EVMB-ICNR internal web site. You are now connected to your EVMB-ICNR remotely through the internet and are able to access it from any place that has an internet connection. 5. EVMB-ICNR Host Website On/off EVMB-ICNR Module Serial number EVMB-ICNR IP Address EVMB-ICNR Module MAC address The GPIO pins corresponds to the ones on the EVMB.