LISIPAROIWHT-01 Cyntech

Soldering the header on to the LISIPAROI A small amount of soldering is needed to add the LISIPAROI header to the board. A selection of different postitions is possible depending on your project and placement. Choose your desired header that you require and using a small amount of BluTac to hold the header in place, add the soldering iron to the first pin, followed by the solder wire. Repeat this until all the headers have been soldered in place. Attaching to the camera module Push the bolts through the LISIPAROI and screw the nut on to the back. Add the camera module, and screw the remaining 2 nuts to hold it all in place. Trim the bolts to the desired length. Dont cut yet if you are planning to add any bracket/support.