900 MHZ WIRELESS ETHERNET BRIDGE XPRESS ETHERNET BRIDGE The XPress Ethernet Bridge provides a secure point-to-point or point-to-multipoint IP connection without the expense and limitations of physical cabling The XPress Ethernet Bridge replaces costly wiring with a available radio channel at start-up, monitor the signal- solution that can wirelessly connect industrial PLCs, digital to-noise ratio and move the network to a new channel if signs, security cameras, access controllers and more. With a necessary. A web interface simplifies installation, allows range of up to 15 miles, the ability to transmit through as many users to monitor packet success and signal strength and as 10 standard walls, a 1.5 Mbps data rate, and the added facilitates remote troubleshooting. range and capabilities of the 900 MHz band, the easy-to-use, The XPress Ethernet Bridge is housed in a weatherproof long-range XPress Ethernet Bridge communicates where Wi-Fi enclosure. It is available in pre-paired units or single units for and other wireless data products fall short. point-to-multipoint applications. The XPress Ethernet Bridge features a built-in spectrum analyzer, allowing users to monitor RF interference. Frequency agility enables the product to automatically select the best BENEFITS APPLICATION EXAMPLE Easy-to-use web interface simplifies configuration and remote troubleshooting Check packet success and signal strength with the web interface Outdoor line-of-sight range of up to 15 miles CENTRAL OFFICE (with high gain antenna) XPRESS ETHERNET BRIDGE AES encryption, FIPS 197 and optional FIPS 140-2 provide secure communication Built-in NAT supports multiple IP client devices RF Signal Frequency agility ensures reliable connection between radios Industrial PLC Network Camera OR OR Monitor RF interference with built-in spectrum analyzer RELARELATED PRODUCTED PRODUCTTSS Access Controller Network Printer OR OR XPRESS ETHERNET BRIDGE XTend Digi XLR Pro ConnectPort XBee ZigBee XBee ZigBee RF Modem X2 Module Adapter VoIP Phone Wi-Fi AccessSPECIFICASPECIFICATIONSTIONS XPress Ethernet Bridge PERFORMANCE Up to 1000 ft (300 m) w/ 2.1 dB dipole antenna INDOOR/URBAN RANGE Up to 2 miles (3.2 km) w/ 2.5 dB dipole antenna, Up to 15 miles (24 km) w/ high-gain antenna OUTDOOR/RF LINE-OF-SIGHT RANGE 125 mW (+21 dBm), 4W EIRP w/ 15 dBi antenna TRANSMIT POWER OUTPUT 935 Kbps THROUGHPUT DATA RATE 1.536 Mbps RF DATA RATE RECEIVER SENSITIVITY -97 dBm ( 10e-4 BER) FEATURES SUPPPORTED PROTOCOLS TCP/IP, Rockwell (RSLinx EtherNet/IP, CSP), Modbus/TCP BROWSER MANAGEMENT TOOLS QoS statistics, Network settings, Spectrum analyzer, Firmware upgrading DATA CONNECTION 10/100Base-T RJ-45, Auto MDI/MDIX INTERFERENCE IMMUNITY DSSS (Direct Sequence Spread Spectrum) ENCRYPTION 128-bit AES, FIPS 197/NIST certified (optional FIPS 140-2) RADIO CHANNELS/BANDWIDTH 12 channels (6 in international version) with 2.0833 MHz spacing and 1.75 MHz occupied bandwidth FREQUENCY BAND ISM 902-928 MHz (915-928 MHz international version) FREQUENCY AGILITY Radio channel automatically selected and adaptively optimized MANUAL FREQUENCY MODE Channel selected with DIP switch or web browser interface STATUS LEDS Power, RF TX/RX, Ethernet link, channel, link quality ERROR-CORRECTION TECHNIQUE Sub-block error detection and retransmission ADJACENT-BAND REJECTION >60 dB - SAW receiver filter attenuates cellular and pager interference REGULATOR TYPE Switching regulator RF RPTNC female ANTENNA CONNECTOR Proprietary system included POE (POWER OVER ETHERNET) Up to 16 active (63 total) per access point SUBSCRIBER UNITS Yes SERIAL NUMBER BASED MATING PROTOCOL 7.9 in x 3.6 in x 2.4 in (20.0 cm x 9.1 cm x 6.1 cm) 415 grams DIMENSIONS (L XW X H) AND WEIGHT POWER REQUIREMENTS Transmit: 1.7W, Receive: 0.8W POWER CONSUMPTION 9 - 48 VDC Power over Ethernet, 175 mA at 9 VDC, 140 mA at 12 VDC, 35 mA at 48 VDC TRANSMIT CURRENT DRAW Use PoE injector, power jack P5-2.1 mm center positive POWER CONNECTOR ENVIRONMENTAL OPERATING TEMPERATURE Radio/Enclosure: -40 C to +70 C POE injector: -40 C to +85 C Power supply: 0 C to +40 C WEATHERPROOFING The XPress Ethernet Bridge is IP65 rated. The PoE injector and power supply are not weatherproof and should be installed indoors. REGULATORY APPROVALS FCC (U.S.A) Yes IC (CANADA) Yes ETSI (EUROPE) N/A C-TICK (AUSTRALIA) Yes TELEC (JAPAN) N/A PART NUMBERS DESCRIPTION XEB09-CIPA XPress Ethernet Bridge, Pair XEB09-CIPAF XPress Ethernet Bridge, Pair - with FIPS 140-2 XEB09-CIPA-W XPress Ethernet Bridge, Pair (International) XEB09-CISA XPress Ethernet Bridge, Single XEB09-CISAF XPress Ethernet Bridge, Single - with FIPS 140-2 XEB09-CISAFB XPress Ethernet Bridge, Radio Board - with FIPS 140-2 XEB09-CISA-W XPress Ethernet Bridge, Single (International) DIGI INTERNATIONAL WORLDWIDE HQ DIGI INTERNATIONAL SINGAPORE DIGI SERVICE AND SUPPORT / You can purchase with confidence knowing that Digi is always available to serve you with expert technical support and our industry 877-912-3444 / 952-912-3444 / www.digi.com +65-6213-5380 leading warranty. For detailed information visit www.digi.com/support. DIGI INTERNATIONAL FRANCE DIGI INTERNATIONAL CHINA 1996-2015 Digi International Inc. All rights reserved. +33-1-55-61-98-98 / www.digi.fr +86-21-50492199 / www.digi.com.cn All trademarks are the property of their respective owners. 91001402 DIGI INTERNATIONAL JAPAN D1/915 +81-3-5428-0261 / www.digi-intl.co.jp