MYPROTO PROTOBOARD FOR NI MYDAQ & MYRIO Digilent

1300 Henley Court Pullman, WA 99163 509.334.6306 www.digilentinc.com myProto Reference Manual Revised November 14, 2014 This manual applies to the myProto rev. A Overview The Digilent myProto accessory board for NI myDAQ attaches directly to the myDAQ and brings all myDAQ signals to breadboard connections where they can be easily accessed using simple jumper wires. The myProto also includes several additional useful I/O devices. Signal names on the myProto breadboards indicate which myDAQ signals and onboard devices are attached to which breadboard pins. All Ground connections on the myProto breadboards are connected into a single Ground node on the myProto device. Solderless Breadboard All myDAQ signals accessible from breadboards 3 onboard user LEDs 1 10K Potentiometer 2 Audio Jacks External power connector for breadboard circuits Switches on all power supplies The Digilent myProto board. Pin Function Pin Function Pin Function AJ1 S1 Audio Jack 1 Sleeve AJ2 T2 Audio Jack 2 Tip AO 1 Analog Out Pin 1 AJ1 T1 Audio Jack 1 Tip AJ2 R2 Audio Jack 2 Ring AI0 GND Analog In Ground AJ1 R1 Audio Jack 1 Ring PWR 5V myDAQ +5V supply AI0 0+ Analog In Ch0+ PWR +15V myDAQ +15V PWR GND Ground AI0 0- Analog In Ch0- supply PWR -15V myDAQ -15V supply PWR Vext From Vext Jack AI1 GND Analog In Ground PWR GND Ground AO GND Ground AI1 1+ Analog In Ch1+ AJ2 S2 Audio Jack 2 Sleeve AO 0 Analog Out Pin 0 AI1 1- Analog In Ch1- DIG GND Digital GND DIG DIO4 Digital I/O 4 LED Y Yellow LED DIG DIO0 Digital I/O 0 DIG DIO5 Digital I/O 5 LED R Red LED DIG DIO1 Digital I/O 1 DIG DIO6 Digital I/O 6 Pot CCW Pot Counter-CW DIG DIO2 Digital I/O 2 DIG DIO7 Digital I/O 7 Pot Wiper Pot Wiper DIG DIO3 Digital I/O 3 LED G Green LED Pot CW Pot CW Table 1. Digilent myProto signals. Copyright Digilent, Inc. All rights reserved. DOC : 6002-502-007 Page 1 of 2 Other product and company names mentioned may be trademarks of their respective owners. myProto Reference Manual Figure 1. Connecting Digilent myProto to the NI myDAQ. When Pot turned CCW, LED G, Y, R CCW wiper approaches CCW pin R decreases W-CCW and R increases W-CW Wiper (S) Sleve (Ground) When Pot turned CW, (R) Ring (Right) wiper approaches CW (T) Tip (Left) pin R decreases W-CW CW and R increases W-CCW LED Circuit Potentiometer Circuit Audio Jack Connections Figure 2. Digilent myProto circuits and breadboard device connections. Copyright Digilent, Inc. All rights reserved. Page 2 of 2 Other product and company names mentioned may be trademarks of their respective owners. 390 W 10K W