AH3582 HIGH VOLTAGE HIGH SENSITIVITY HALL EFFECT OMNIPOLAR WITH INTERNAL PULL UP RESISTOR Description Pin Assignments The AH3582 is a high voltage high sensitivity Hall Effect Omnipolar (TOP View) switch IC designed for proximity, position and level sensing in industrial and consumer home appliances and personal care 3 OUTPUT applications. To support wide range of demanding applications, the GND 2 design has been optimized to operate over the supply range of 3.0V 1 V DD to 28V. With chopper stabilized architecture and an internal bandgap regulator to provide temperature compensated supply for internal SOT23 circuits, the AH3582 provides a reliable solution over the whole operating range. For robustness and protection, the device has a reverse blocking diode with a Zener clamp on the supply. The output (TOP View) has an over current limit and a Zener clamp. 3. OUTPUT The internally pulled-up output can be switched on with either South 2. GND or North pole of sufficient strength. When the magnetic flux density 1. V DD (B) perpendicular to the package is larger than the operate point (B ) the output is switched on (pulled low) and is held on until SIP-3 (Bulk Pack) OP magnetic flux density B is lower than the release point (B ). RP Applications Features Position and Proximity Sensing in Industrial Applications Omnipolar Operation Applications High Sensitivity: B and B of 40G and 25G Typical OP RP Open and Close Detect Internally Pull-up Resistor on the Output with Over Current Limit Position Detect 3.0V to 28V Operating Voltage Range Level Detect Chopper Stabilized Design Provides Flow Meters o Superior Temperature Stability Contact-less Switches o Minimal Switch Point Drift o Enhanced Immunity to Stress Good RF Noise Immunity Reverse Blocking Diode Zener Clamp on Supply and Output Pins -40C to +125C Operating Temperature ESD: HBM 6kV Industry Standard SOT23 and SIP-3 (Ammo Pack), SIP-3 (Bulk Pack) Packages Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2) Halogen and Antimony Free. Green Device (Note 3) Notes: 1. No purposely added lead. Fully EU Directive 2002/95/EC (RoHS), 2011/65/EU (RoHS 2) & 2015/863/EU (RoHS 3) compliant. 2. See Low-Pass Filter Sample and Hold Dynamic Offset Cancellation AH3582 Typical Applications Circuit 3.0V to 28V V DD OUTPUT AH3582 C IN GND Note: 4. C is for power stabilization and to strengthen the noise immunity, the recommended capacitance is 10nF ~ 100nF. IN Pin Descriptions Package: SOT23 and SIP-3 (Ammo Pack), SIP-3 (Bulk Pack) Pin Number Pin Name Function 1 V Power Supply Input DD 2 GND Ground 3 OUTPUT Output Pin Functional Block Diagram V DD Power switch To All Subcircuits OUTPUT Amp Amp Control Current Limit GND 2 of 13 AH3582 July 2018 Diodes Incorporated www.diodes.com Document number: DS41183 Rev. 1 - 2 NEW PRODUCT