DBS-2100 MANUAL BANDING TOOL FOR STAMPED BUCKLE BANDS DATASHEET SEE PAGE 20 FOR IMPORTANT INFORMATION CONCERNING LIMITED WARRANTY AND LIMITATION OF LIABILITY. INTRODUCTION The Daniels DBS-2100 (M81306/1A) Manual Banding tool is primarily designed for termination of EMI/RFI shielding materials. If there is a disagreement between the assembly process described herein and the connector/accessory suppliers instructions, or an OEM approved process, the latter documents shall have priority. Consult DMC for further information. 1.0 Tool Components and Operation Instructions Step 1: Prepare the Connector and Cable Braid Terminate wire/contact assemblies and insert them into the connector. Prepare the cable braid for band termination process (See section 2.0 on page 5). DANIELS MANUFACTURING CORP., 526 THORPE ROAD, ORLANDO, FL 32824, USA PHONE (407)855-6161 FAX (407) 855-6884 WWW.DMCTOOLS.COM E-MAIL: DMC DMCTOOLS.COM COPYRIGHT 2014 ALL RIGHTS RESERVED REV. D 8/14 DOC. DBS-2100-DS 2 Step 2: Prepare band Using a stamped buckle band, feed the end of the band through the narrow slot on the buckle twice until the indicator mark is within approximately .250 of the buckle slot. This will create a double looped band. Never use a single looped band with the DBS-2100. To hasten the termination process on smaller adaptors, pull on the end of the band to reduce the diameter of the loop. NOTICE Application: For M85049/128-3 and -4 shield bands only. Do not use the DBS- 2100 One Step Banding Tool on M85049/128-1 and -2 welded buckle bands. Consult DMC for tool selection for other shield bands Step 3: Insert looped band into tool Squeeze the grey release lever on the DBS-2100 and insert the end of the band into the nose of the tool. Ensure the orientation of the band matches the graphic on the body of the tool. DANIELS MANUFACTURING CORP., 526 THORPE ROAD, ORLANDO, FL 32824, USA PHONE (407)855-6161 FAX (407) 855-6884 WWW.DMCTOOLS.COM E-MAIL: DMC DMCTOOLS.COM COPYRIGHT 2014 ALL RIGHTS RESERVED REV. D 8/14 DOC. DBS-2100-DS