DBS-CG8 VERIFICATION INSPECTION GAGE FOR DBS-2200 BANDING TOOL DATASHEET SEE PAGE 8 FOR IMPORTANT INFORMATION CONCERNING LIMITED WARRANTY AND LIMITATION OF LIABILITY. INTRODUCTION The Daniels DBS-CG8 (M81306/1D) Verification Inspection Gage is designed for verifying the pre-set tension of the DBS-2200 manual banding tool. Reference DBS-2200 datasheet for the proper operation of the banding tool. Consult DMC for further information. 1.0 Gage Components and Operation Instructions Warning: Keep the DBS-CG8 in a clean, dry place when not in use. Keep the inspection window free from dust and debris. DANIELS MANUFACTURING CORP., 526 THORPE ROAD, ORLANDO, FL 32824, USA PHONE (407)855-6161 FAX (407) 855-6884 WWW.DMCTOOLS.COM E-MAIL: DMC DMCTOOLS.COM COPYRIGHT 2014 ALL RIGHTS RESERVED REV. C 8/14 DOC. DBS-CG8-DS 2 1.1 VERIFYING THE TENSION APPLIED TO THE BAND IS WITHIN 75-85 POUNDS. Step 1: Insert the band into the DBS-CG8 Insert the flat end of a 1/8 wide band through the hole in the DBS-CG8. Pass the band through the DBS-CG8 until the buckle comes into contact with the end of the verification inspection gage. Step 2: Insert the end of the band into the DBS-2200 Squeeze the grey release lever and insert the flat end of the band through the nose of the DBS-2200 far enough for the tools advancement pawl to engage the band (approx. 1.5). The band may be inserted further into the tool to hasten the process. DANIELS MANUFACTURING CORP., 526 THORPE ROAD, ORLANDO, FL 32824, USA PHONE (407)855-6161 FAX (407) 855-6884 WWW.DMCTOOLS.COM E-MAIL: DMC DMCTOOLS.COM COPYRIGHT 2014 ALL RIGHTS RESERVED REV. C 8/14 DOC. DBS-CG8-DS