HPU11M HYDRAULIC POWER UNIT DATASHEET 1.0 IMPORTANT RECEIVING INSTRUCTIONS Visually inspect all components for shipping damage. Shipping Damage is not covered by warranty. If shipping damage is found, notify carrier at once. The carrier is responsible for all repair and replacement cost resulting from damage in shipment. 2.0 SAFETY Read all instructions, warnings, and cautions carefully. Follow all safety precautions to avoid personal injury or property damage during system operation. DMC cannot be responsible for damage or injury resulting from unsafe product use, lack of maintenance, or incorrect product and/or system operation. Contact DMC when in doubt as to the safety precautions and operations. Failure to comply with the following cautions and warnings could cause equipment damage and personal injury. A CAUTION is used to indicate correct operating or maintenance procedures and practices to prevent damage to, or destruction of equipment or other property. A WARNING indicates a potential danger that requires correct procedures or practices to avoid personal injury. HPU11M-DS 2012 Daniels Manufacturing Corp., All Rights Reserved Page 1 of 13 REV. D 5/17/2016 Daniels Manufacturing Corporation 526 Thorpe Road, Orlando, FL 32824 USA Phone: 407-855-6161 Fax: 407-855-6884 Email: DMC dmctools.com HPU11M HYDRAULIC POWER UNIT DATASHEET A DANGER is only used when your action or lack of action may cause serious injury or even death. WARNING: Wear proper personal protective gear when operating hydraulic equipment. DANGER: To avoid personal injury keep hands and feet away from cylinder and work piece during operation. WARNING: Do not exceed equipment ratings. Overloading causes equipment failure and possible injury. The pump is designed for a max. pressure of 700 bars (10,000 psi). DANGER: Never set the relief valve to a higher pressure than the maximum rated pressure of the pump. Higher settings may result in equipment damage and/or personal injury. Do not remove relief valve. CAUTION: Avoid damaging hydraulic hose. Avoid sharp bends and kinks when routing hydraulic hoses. Using a bent or kinked hose will cause severe back pressure. Sharp bends and kinks will internally damage the hose leading to premature hose failure. IMPORTANT: Do not lift hydraulic equipment by the hoses or swivel couplers. Use the carrying handle or other means of safe transport. CAUTION: Keep hydraulic equipment away from flames and heat. For optimum performance do not expose equipment to temperatures of 65 C (150 F) or higher. DANGER: Do not handle pressurized hoses. Escaping oil under pressure can penetrate the skin, causing serious injury. If oil is injected under the skin, see a doctor immediately. IMPORTANT: Hydraulic equipment must only be serviced by a qualified hydraulic technician. For repair service, contact Daniels Manufacturing Corporation. 3.0 SPECIFICATIONS Usable Oil Output Flow Rate Dynamic Weight Capacity Maximum 100psi (6.9bar) Valve Valve Air Air Pressure Type Function Pressure Consumption Liters in No Load Load lb Kg Range 3- 30- 10-35ft/min 10,000psi 120in/min 15in/min way, Adv./Hold 125psi 1.0 61 19.4 8.8 (283-991 (700bar) (2.0l/min) (.25l/min) 3- /Retract (2.1- l/min) pos. 8.6bar) CAUTION: Use of an airline lubricator is strongly recommended. Set the lubricator to provide one drop of oil per minute of continuous operation. Use a high quality air tool oil such as Mobil Almo 525, Shell Torcula 32, or equivalent. HPU11M-DS 2012 Daniels Manufacturing Corp., All Rights Reserved Page 2 of 13 REV. D 5/17/2016 Daniels Manufacturing Corporation 526 Thorpe Road, Orlando, FL 32824 USA Phone: 407-855-6161 Fax: 407-855-6884 Email: DMC dmctools.com