ACE1V3225-220-R Eaton

Effective June 2021 Technical Data 10985 Supersedes November 2019 ACE1V3225 Automotive grade common-mode chip inductor Applications Controller area network (CAN) Ethernet architectures Automotive signal line filter Advanced driver assistance systems (ADAS) Infotainment, safety cameras, sensors, xEV, Powertrain Engine control unit (ECU) Product features Electric power steering system (EPS) AEC-Q200 qualified Battery management systems (BMS) 1210 (3225 metric) package Impedance range from 500 ohms to 15000 Environmental compliance and general ohms specifications Inductance range from 11 uH to 200 uH Operating temperature range: -40 C to +125 C Moisture sensitivity level (MSL): 1 (ambient plus self-temperature rise) Solder reflow temperature: J-STD-020 (latest revision) compliant HALOGEN HF Pb FREEACE1V3225 Technical Data 10985 Effective June 2021 Automotive grade common-mode chip inductor Product specifications Common-mode Common-mode DCR () Insulation impedance Z () at inductance (H) at +25 Idc (mA) Rated voltage resistance Part number 10 MHz 100 kHz maximum maximum (Vdc) typical (M) minimum ACE1V3225-110-R 300 minimum 11+50%/-30% 0.40 300 80 10 500 typical ACE1V3225-220-R 500 minimum 22+50%/-30% 0.50 250 80 10 1000 typical ACE1V3225-510-R 1000 minimum 51+50%/-30% 0.70 200 80 10 2600 typical ACE1V3225-101-R 2200 minimum 100+50%/-30% 1.50 150 80 10 5100 typical ACE1V3225-201-R NA 200+30%/-20% 4.80 70 80 10 1. Part Number Definition: ACE1V3225-xxn-R ACE1V3225 = Product code and size xx= inductance value in uH, n= multiplication factor: 10 n (i.e. 110 = 11 * 10 0 = 11 uH) -R suffix = RoHS compliant Mechanical parameters, schematic, pad layout (mm) Recommended pad layout B A Epoxy C D Terminations Wires E E FF Equivalent circuit 1 4 2 3 No polarity Part number A B C D E F L H G1 G2 ACE1V3225-xxn-R 3.20.2 2.50.2 2.5 max 0.20.1 0.9 typ 08 typ 3.7 typ 2.55 typ 1.9 typ 0.75 typ All soldering surfaces to be coplanar within 0.1 millimeters Tolerances are 0.1 millimeters unless stated otherwise Pad layout dimensions are reference only Traces or vias underneath the inductor is not recommended 2 www.eaton.com/electronics