2218F/2TDHHO ebm papst

7.6 deep Tin-plated 3 Max. 1220 m /h DC axial fans 220 x 200 x 51 mm Material: Housing: Die-cast aluminum Possible special versions: 1) Impeller: GRP (PA) (See chapter DC fans - specials) Direction of air flow: Exhaust over struts - Speed signal Direction of rotation: Counterclockwise, - Go / NoGo alarm looking towards rotor - Alarm with speed limit Connection: Via single wires AWG 18, 20 or - External temperature sensor AWG 22, TR 64, speed signal - Internal temperature sensor and control input AWG 22 - PWM control input Highlights: Highly efficient and smoothly - Analog control input operating 3-phase fan drive - Multi-option control input Housing with grounding lug - Moisture protection for screw M4 x 8 (Torx) - Salt spray protection Weight: 1000 g - Degree of protection: IP 54 1) Fiberglass-reinforced plastic Series 2200 FTD Nominal data 3 -1 Type m /h cfm VDC VDC dB(A) Bel(A) / Watts rpm C Hours Hours 6 3 4 3 6 7 7 4 - 7 1 2214 F/2 TDHO 790 465 24 16...30 62 7.1 35 4250 -20...+75 90 000 / 42 500 152 500 7 4 4 3 7 8 1 4 - 6 1 2214 F/2 TDHHO 940 553 24 16...36 66 7.4 48 5000 -20...+70 85 000 / 42 500 142 500 1 6 4 3 7 8 3 6 - 5 8 2218 F/2 TDHO 790 465 48 36...57 62 7.1 35 4250 -20...+75 90 000 / 42 500 152 500 1 6 4 3 7 8 3 6 - 4 6 2218 F/2 TDHHO 940 553 48 36...72 66 7.4 48 5000 -20...+70 85 000 / 42 500 142 500 2218 F/2 TDH4P 1220 718 48 36...72 72 8.2 103 6500 -20...+65 70 000 / 40 000 117 500 Subject to change -1 Speed control range from 1000 rpm up to maximum nominal speed. Standstill at 0% PWM, Type O: standstill if control wire is interrupted Type P: maximum speed if control wire is interrupted. * Power consumption at free air flow. These values can be significantly higher in the operating point. Air performance measured according to: ISO 5801. Installation category A, without contact protection. Noise: Total sound power level L A ISO 103002 W measured on a hemisphere with a radius of 2 m. Sound pressure level L A measured at 1 m distance from p fan axis. The values given are applicable only under the specified measuring conditions and may differ depending on the installation conditions. In the event of deviation from the standard configuration, the parameters must be checked after installation For detailed information see