DV5212/2N-40184 ebm papst

Tin-plated 3 Max. 320 m /h DC diagonal fan 127 x 38 mm 1) Material: Housing: GRP (PBT) Possible special versions: Available in Die-cast aluminum (See chapter DC fans - specials) Metal flange - Speed signal 1) Impeller: GRP (PA) - Go / NoGo alarm Direction of air flow: Exhaust over struts - Alarm with speed limit Direction of rotation: Counterclockwise, - External temperature sensor looking towards rotor - Internal temperature sensor Connection: Via single wires AWG 22, - PWM control input TR 64 - Analog control input Highlights: Housing with grounding lug for - Moisture protection screw M4 x 8 (Torx) - Salt spray protection Weight: 415 g (with metal housing: 490 g) - Degree of protection: IP 54 1) Fiberglass-reinforced plastic Series DV 5200 Nominal data 3 -1 Type m /h cfm VDC VDC dB(A) Bel(A) / Watts rpm C Hours Hours 1 1 7 4 5 4 2 - 6 1 DV 5212 N 270 159 12 9...15 56 6.4 21.0 5 000 -20...+65 70 000 / 40 000 117 500 2 1 7 4 5 6 3 - 5 9 DV 5214 N 270 159 24 16...30 56 6.4 20.4 5 000 -20...+65 70 000 / 40 000 117 500 2 1 7 5 6 9 3 - 4 7 DV 5218 N 270 159 48 36...60 56 6.4 18.5 5 000 -20...+65 70 000 / 40 000 117500 3 1 9 5 6 1 4 - 4 7 Standard model comes with speed signal and PWM control input. Other versions by request. 1 2 1 4 5 4 2 - 6 1 DV 5214/2 HP 320 188 24 16...30 62 7.2 38.5 6 000 -20...+65 62 500 / 35 000 105 000 2 2 1 4 5 6 3 - 5 9 Subject to change 2 2 1 5 6 9 3 - 4 7 -1 Speed control range from 1000 rpm up to maximum nominal speed. 3 2 1 5 6 1 4 - 4 7 Standstill at 0% PWM, maximum speed if control cable is interrupted. * Power consumption at free air flow. These values can be significantly higher in the operating point. 1 4 3 4 5 4 2 - 6 1 2 4 3 4 5 6 3 - 5 9 2 4 3 5 6 9 3 - 4 7 3 4 3 5 6 1 4 - 4 7 Air performance measured according to: ISO 5801. Installation category A, without contact protection. Noise: Total sound power level L A ISO 103002 W measured on a hemisphere with a radius of 2 m. Sound pressure level L A measured at 1 m distance from p fan axis. The values given are applicable only under the specified measuring conditions and may differ depending on the installation conditions. In the event of deviation from the standard configuration, the parameters must be checked after installation For detailed information see