400A Elkay

12907 ELKAY 400A COLUMBUS TIMER INSTRUCTIONSv5 Layout 1 26/09/2013 16:50 Page 1 columbus timer Installation Instructions PRODUCT: 400A SINGLE CONTACT PUSH BUTTON TIMER PRODUCT: 400A-3 DOUBLE CONTACT PUSH BUTTON TIMER Incandescent 6A Compact Fluorescent 3A (6 ttings max) Resistive 6A Fluorescent 3A (6 ttings max) Voltage 230Vac Time Delay 5 sec - 5 min The Columbustimer is part of the Elkay family of time switches and detectors which save energy and increase convenience in and around your home or business premises. 1. Mounting: The 400A is ideally suitable for mounting on most standard square boxes with two mounting lugs. Any additional mounting lugs found on a metal box must be ground off in case it causes an obstruction or short circuit with unit. Avoid over tightening the mounting screws as this may cause the switch cover to distort and lock the plunger in the ON position. 2. Operation: The switch is operated by pressing the plunger in to make or break the circuit. The plunger will gradually return to its normal position during the time delay. It is normal to occasionally see a ash when the switch contacts make or break. DIAGRAM 1 Single contact timers only have one 3. Timing Adjustment: Delay timing is set and adjusted by turning the timing screw at the back of the unit, clockwise to increase and anti-clockwise to set of contacts tted. decrease the time delay. Close attention must be paid when making adjustment. For accuracy slight rotation of the timing screw is needed when setting the time delay. Start by turning the timing screw so that its level with the top of the screw thread. Make slight adjustments from there, checking the time delay after each adjustment. Sometime this slight adjustment of the timing screw may not result in any changes to the time delay and this is due to the mechanical nature of the timing COM - Common mechanism. Continue with the adjustment until the desired NO - Normally Open time delay is reached. Please note due to the mechanical setting, there may be a variation in the time delay from one NC - Normally Closed push to the next. Timing Screw DIAGRAM 2 DIAGRAM 3 Typical Circuit for Corridor Lighting Typical Circuit for Staircase Lighting where (i.e. Lights will stay on until the last timer goes off). the Live and Switched Live are at different positions. TIMER TIMER TIMER TIMER TIMER TIMER LIVE IN LIVE IN NEUTRAL NEUTRAL Switched Live Switched Live Switched Live IMPORTANT NOTICE All wiring should be carried out by a competent person or a qualied electrician and should be tted to IEE 17th Edition Wiring regulations BS7671:2008. The circuit should be isolated before carrying out any work. Failure to adhere to the instructions will invalidate the warranty. TECHNICAL HELPLINE For further help, or information on this and the other products in the Elkay range visit www.elkay.co.uk or call 01675 468222. Elkay Electrical, Coleshill, Birmingham, B46 1HT Tel: +44 (0) 1675 468222 www.elkay.co.uk Columbus is a registered trademark of Elkay Electrical. Inst. Ref. No 900 - 3020 Rev. No.: 09/13 RPM400X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for elkay manufacturer: Other Similar products are found below : 550B-1 AQUASAFE PFCC-1 041852X 041854F 041874R 1278 1275 1276-18 2001/4/CG/4