FCP-M1-XPE1-0R Fraen

FCP Lens series for Cree XP-E and XP-G LEDs High efficiency 4 beams available Easy assembly The FCP lens offers low-profile lenses specifically designed for the XP-E and XP-G XLamp LEDs from Cree Corporation. A software-optimized aspheric profile enables the generation of several different beam output patterns: narrow, medium, elliptical, and wide beams. The high collection efficiency reaches 85% of the total flux emitted by the LEDs. Lens holders are available in black PC, Cree XLamp is a trademark of Cree, Inc. For technical and provide the proper alignment information about these LEDs please refer to the Cree between the LEDs and the lenses, and XLamp datasheet or visit: set the correct distance between the General Characteristics ________________________________________________________________ Lens Material Optical Grade PMMA Holder Material PC, black color Operating Temperature range -40deg C / + 80 deg C Storage Temperature range -40deg C / + 80 deg C Average transmittance in visible spectrum (400 700nm) >90%, as measured using 3mm thick Optical Grade PMMA. Please note that flow lines and weld lines on the external surfaces of the lenses are acceptable if the optical performance of the lens is within the specification described in the section OPTICAL CHARACTERISTICS. IMPORTANT NOTE Lenses handling and cleaning: Handling: Always use gloves to handle lenses and/or handle the lenses only by the flange. Never touch the outside surfaces of the lenses with fingers; finger oils and contamination will absorb or refract light. Cleaning: Clean lenses only if necessary. Use only soap and water to clean the surfaces and lenses. Never expose the lenses to solvents such as alcohol, as it will damage the plastic. Scope ________________________________________________________________ This datasheet provides information about the FCP series lenses: FCP-N1-XPE1-0R FCP-M1-XPE1-0R FCP-W1-XPE1-0R FCP-E1-XPE1-0R and lens assemblies: FCP-N1-XPE1-HRF FCP-M1-XPE1-HRF FCP-W1-XPE1-HRF FCP-E1-XPE1-HRF These lenses and assemblies may be used on either the Cree XP-E or XP-G LEDs. _______________________________________________________________________ 2/8 FCP series lenses for Cree XP-E and XP-G LEDs