Safety Data Sheet Revision Number: 006.0 Issue date: 08/04/2014 1. PRODUCT AND COMPANY IDENTIFICATION Product name: LOCTITE 411 INSTANT ADHESIVE IDH number: 233768 known as 411 Prism Clear Toughened Ins Product type: Cyanoacrylate Item number: 41104 Restriction of Use: None identified Region: United States Company address: Contact information: Henkel Corporation Telephone: (860) 571-5100 One Henkel Way MEDICAL EMERGENCY Phone: Poison Control Center Rocky Hill, Connecticut 06067 1-877-671-4608 (toll free) or 1-303-592-1711 TRANSPORT EMERGENCY Phone: CHEMTREC 1-800-424-9300 (toll free) or 1-703-527-3887 Internet: www.henkelna.com 2. HAZARDS IDENTIFICATION EMERGENCY OVERVIEW WARNING: BONDS SKIN IN SECONDS. COMBUSTIBLE LIQUID. CAUSES EYE IRRITATION. MAY CAUSE RESPIRATORY IRRITATION. HAZARD CLASS HAZARD CATEGORY FLAMMABLE LIQUID 4 EYE IRRITATION 2B SPECIFIC TARGET ORGAN TOXICITY - SINGLE EXPOSURE 3 PICTOGRAM(S) Precautionary Statements Prevention: Keep away from heat,sparks, open flames, hot surfaces - no smoking. Avoid breathing vapors, mist, or spray. Wash thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear protective gloves, eye protection, and face protection. Response: IF INHALED: Remove person to fresh air and keep comfortable for breathing. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to remove. Continue rinsing. Call a poison control center or physician if you feel unwell. If eye irritation persists: Get medical attention. In case of fire: Use foam, dry chemical or carbon dioxide to extinguish. Storage: Store in a well-ventilated place. Keep container tightly closed. Store in a well-ventilated place. Keep cool. Store locked up. Disposal: Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations. IDH number: 233768 Product name: LOCTITE 411 INSTANT ADHESIVE known as 411 Prism Clear Toughened Ins Page 1 of 6 Classification complies with OSHA Hazard Communication Standard (29 CFR 1910.1200) and is consistent with the provisions of the United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS). See Section 11 for additional toxicological information. 3. COMPOSITION / INFORMATION ON INGREDIENTS Hazardous Component(s) CAS Number Percentage* Ethyl 2-cyanoacrylate 7085-85-0 60 - 100 Thickener Proprietary 10 - 30 Filler Proprietary 1 - 5 * Exact percentage is a trade secret. Concentration range is provided to assist users in providing appropriate protections. 4. FIRST AID MEASURES Inhalation: Move to fresh air. If breathing is difficult, give oxygen. If not breathing, give artificial respiration. If symptoms develop and persist, get medical attention. Skin contact: Do not pull bonded skin apart. Soak in warm soapy water. Gently peel apart using a blunt instrument. If skin is burned due to the rapid generation of heat by a large drop, seek medical attention. If lips are bonded, apply warm water to the lips and encourage wetting and pressure from saliva in mouth. Peel or roll lips apart. Do not pull lips apart with direct opposing force. Eye contact: Immediately flush with plenty of water for at least 15 minutes. Get medical attention. If eyelids are bonded closed, release eyelashes with warm water by covering with a wet pad. Do not force eye open. Cyanoacrylate will bond to eye protein and will cause a lachrymatory effect which will help to debond the adhesive. Keep eye covered until debonding is complete, usually within 1-3 days. Medical attention should be sought in case solid particles of polymerized cyanoacrylate trapped behind the eyelid caused abrasive damage. Ingestion: Ensure breathing passages are not obstructed. The product will polymerize rapidly and bond to the mouth making it almost impossible to swallow. Saliva will separate any solidified product in several hours. Prevent the patient from swallowing any separated mass. Symptoms: See Section 11. Notes to physician: Surgery is not necessary to separate accidentally bonded tissues. Experience has shown that bonded tissues are best treated by passive, non-surgical first aid. If rapid curing has caused thermal burns they should be treated symptomatically after adhesive is removed. 5. FIRE FIGHTING MEASURES Extinguishing media: Water spray (fog), foam, dry chemical or carbon dioxide. Special firefighting procedures: Wear a self-contained breathing apparatus with a full face piece operated in pressure-demand or other positive pressure mode. Unusual fire or explosion hazards: None IDH number: 233768 Product name: LOCTITE 411 INSTANT ADHESIVE known as 411 Prism Clear Toughened Ins Page 2 of 6