TechnicalData Sheet TEROSON VR 5080 Known as LOCTITE Teroson 5080 July-2015 PRODUCT DESCRIPTION GENERAL INFORMATION TEROSON VR 5080 provides the following product For safe handling information on this product, consult the Safety Data Sheet (SDS). characteristics: Technology Tape Directions for use: ChemicalType Synthetic Rubber The tape can be torn easily and neatly by hand. Ensure that Appearance Metallicgray surfaces are clean,free of grease and dry. Cure Non-curing Application Fix & Repair Tape For maximum adhesion and durability,press the tape firmly to Key Substrates Most surfaces the bonding surface. Ifnecessary apply more layers. For best results, use at an ambient temperature. TEROSON VR 5080 is a multi- purpose adhesive tape ideal for repairing, reinforcing, fixing, sealing and protecting parts. Not for product specifications The technicaldata contained herein are intended as reference Suitable for most surfaces. The tape incorporates a 3-layer only. Please contact your localquality department for technology consisting of 1) a synthetic rubber adhesive layer, assistance and recommendations on specifications for this 2) an integrated fabriclayer and 3) a waterproof layer of product. polyethylene. Suitablefor indoor and outdoor application . Storage Store product in a cool dry place away from direct sunlight and TYPICAL PROPERTIES heat sources. Optimal Storage: 8 C to 21 C. Storage Total Thickness, m 226 below 8 C or greater than 28C can adversely affect Width, mm 50 product properties . Henkel Corporation cannot assume responsibility for product which has been stored under Length, m 25 or 50 conditions other than those previously indicated. Ifadditional Core, mm 76.2 information is required, please contact your localTechnical Service Center or Customer Service Representative. Conversions TYPICAL PERFORMANCE (C x 1.8)+ 32 =F Tensile Strength ,EN 1940 N/cm 42 kV/mm x 25.4 =V/mil lb/in 3.7 mm /25.4 =inches Adhesion to steel ,EN 1939 N/25mm 43.5 m /25.4 =mil lb/in 9.9 N x 0.225=lb Rollingball,PSTC 6 cm 0 N/mm x 5.71=lb/in in 0 N/mm x 145 =psi Shear Resistance 22 C , ASTM D 3654 , >168 MPa x 145 =psi hours Nm x 8.851 = lbin Nm x 0.738=lbft Nmm x 0.142 =ozin TYPICAL ENVIRONMENTAL RESISTANCE mPas =cP Note: The information provided in this Technical Data Sheet (TDS) including the Leakage Stop Performance recommendations for use and application of the product are based on our knowledge and experience of the product as at the date of this TDS. The product Emergency stop of leakages in pipes up to 4 bar pressure for can have a variety of different applications as wellas differingapplication and minimum 1 hour at 22 C .Test results measured at steel pipe working conditions in your environment that are beyond our control. Henkel is, therefore, not liablefor the suitability of our product for the production processes with a holeof 3 mm, covered by a single layer of TEROSON and conditions in respect of which you use them, as wellas the intended VR 5080 . applications and results. We strongly recommend that you carry out your own prior trials to confirm such suitability of our product. Not recommended for permanent repair of leakages. Any liabilityin respect of the information in the TechnicalData Sheet or any other written or oral recommendation(s) regarding the concerned product is excluded, except ifotherwise explicitlyagreed and except in relation to death or personal TDS TEROSON VR 5080 , July-2015 injury caused by our negligence and any liabilityunder any applicablemandatory product liabilitylaw. In case products are delivered by Henkel Belgium NV, Henkel Electronic Materials NV,Henkel Nederland BV, Henkel Technologies France SAS and Henkel France SA please additionally note the following: In case Henkel would be nevertheless heldliable,on whatever legalground, Henkels liabilitywillin no event exceed the amount of the concerned delivery. In case products are delivered by Henkel Colombiana, S.A.S.the following disclaimer is applicable: The information provided in this Technical Data Sheet (TDS) including the recommendations for use and application of the product are based on our knowledge and experience of the product as at the date of this TDS. Henkel is, therefore, not liablefor the suitability of our product for the production processes and conditions in respect of which you use them, as wellas the intended applications and results. We strongly recommend that you carry out your own prior trials to confirm such suitability of our product. Any liabilityin respect of the information in the TechnicalData Sheet or any other written or oral recommendation(s) regarding the concerned product is excluded, except ifotherwise explicitlyagreed and except in relation to death or personal injury caused by our negligence and any liabilityunder any applicablemandatory product liabilitylaw. In case products are delivered by Henkel Corporation, Resin Technology Group, Inc., or Henkel Canada Corporation, the following disclaimer is applicable: The data contained herein are furnished for information only and are believedto be reliable.We cannot assume responsibility for the results obtained by others over whose methods we have no control. It is the user s responsibility to determine suitability for the user s purpose of any production methods mentioned herein and to adopt such precautions as may be advisable for the protection of property and of persons against any hazards that may be involved in the handling and use thereof. In lightof the foregoing, Henkel Corporation specifically disclaims all warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose, arising from sale or use of Henkel Corporations products. Henkel Corporation specifically disclaims any liability for consequential or incidental damages of any kind, including lost profits. The discussion herein of various processes or compositions is not to be interpreted as representation that they are free from domination of patents owned by others or as a license under any Henkel Corporation patents that may cover such processes or compositions. We recommend that each prospective user test his proposed application before repetitive use, using this data as a guide. This product may be covered by one or more United States or foreign patents or patent applications. Trademark usage Except as otherwise noted, alltrademarks in this document are trademarks of Henkel Corporation in the U.S. and elsewhere. denotes a trademark registered in the U.S. Patent and Trademark Office. Reference 1.1 Henkel Americas Henkel Europe Henkel Asia Pacific +860.571.5100 +49.89.320800.1800 +86.21.2891.8859 For the most direct access to local sales and technical support visit: www.henkel.com/industrial