Model 3397 Tension/Compression Pancake Load Cell DESCRIPTION Minimum deflection and compactness make these general- These general purpose designs have exceptional structural purpose load cells easy to install and use. capability to withstand extraneous loads, such as torque, bending moments, and side loads. Available in capacities of 25 lb to 300 lb, they offer maximum performance and enhanced accuracy. FEATURES Up to 0.05 % accuracy 25 lb to 300 lb range Low sensitivity to extraneous loads Low deflection Built-in temperature compensationModel 3397 TYPICAL SYSTEM DIAGRAM PERFORMANCE SPECIFICATIONS Characteristic Measure In-Line Amplifiers Customer Supplied 1 Load range 25, 50, 100, 200, 300 lb (Used with unamplified units only) Chart Recorder Alarm Panel Non-linearity 0.05 % of rated output Amplifier Output Data Acquisition Universal In-Line Amplifiers Hysteresis 0.05 % of rated output Computer UV +/-5 VDC PLC UV-10 +/-10 VDC Repeatability 0.02 % of rated output 0 +/-5 VDC UBP U3W 4-20mA (3 wire) Output rated capacity 2 mV/V 0.25 % (nominal) U2W 4-20mA (2 wire) Operation Tension/compression DIN rail Mount In-Line Amplifiers Power Supply DV-05 0 +/- 5 VDC (3 wire) Resolution Infinite DA-05 4-20mA (3 wire) 0 +/- 10 VDC (3 wire) DV10 Standard calibration Tension (+) and compression (-) Honeywell In-Line Amplifier Output Input ENVIRONMENTAL SPECIFICATIONS Serial Number Characteristic Measure Display Units Temperature, operating -54 C to 93 C -65 F to 200 F SC500 SC1000 SC2000 Temperature, compensated 21 C to 77 C 70 F to 170 F SC2001 SC3004 GM NK HH Temperature effect, zero 0.002 % of rated output/F 7541 7558 7561-PSD Temperature effect, output 0.002 % of reading/F MODEL 3397 2003.1 lb. ELECTRICAL SPECIFICATIONS OR L1 L2 L3 L4 VALUE CLEAR CHAN TARE Characteristic Measure UP DOWN SETUP ENTER EXIT Strain gage type Foil Mating Connectors & Cables Excitation (maximum) 20 Vdc or Vac RMS Insulation resistance > 5000 mOhm 50 Vdc 023-LW181-023-LF Mating Connector 7205-76-XX* Mating connector & 6 conductor cable Bridge resistance 350 ohm (unamplified unit with sense leads but not shunt cal) (tolerance) 7205-75-XX** Mating connector & 4 conductor cable (unamplified unit without sense leads but not shunt cal) Number of bridges 1 or 2 7205-83-XX* Mating connector & 6 conductor cable (for connection to instrument 7541) Zero balance 5.0 % 7205-82-XX** Mating connector & 4 conductor cable Electrical termination PT02E-10-6P mates with PT06W-10-6S (for connection to instrument 7541) * XX represents length in feet 100ft maximum ** XX represents length in feet 20ft maximum MECHANICAL SPECIFICATIONS Characteristic Measure Static overload capacity 150 % of nominal capacity Material Carbon steel Natural frequency See table WIRING CODES Cable Red (+) excitation Black (-) excitation Green (+) output White (-) output 2 Honeywell Sensing and Control