SDP8614-301 Honeywell

SDP8604/8614 Optoschmitt Detector 10 k Ohm Pull-Up Output FEATURES Side-looking plastic package 55 (nominal) acceptance angle TTL/LSTTL/CMOS compatible 10 pullup output Buffer or inverting logic available High noise immunity output Mechanically and spectrally matched to SEP8506 and SEP8706 infrared emitting diodes INFRA--8.TIF DESCRIPTION OUTLINE DIMENSIONS in inches (mm) The SDP8604/8614 series consists of a high speed IC Tolerance 3 plc decimals 0.005(0.12) molded in a side-looking black plastic package to 2 plc decimals 0.020(0.51) minimize the effect of visible ambient light. The detector incorporates a Schmitt trigger which provides pulse .175 .060 shaping and hysteresis for noise immunity. Detector (4.45) (1.52) output is an NPN silicon transistor with a 10 k .060 .030 (nominal) pull-up resistor. This option eliminates the (1.52) (0.76) need for an external load resistor to generate an output signal voltage. Output rise and fall times are .225 .045 independent of rate of change of incident light. Detector (5.72) (1.14) sensitivity has been internally temperature compensated. For additional output configuration .020 SQ. 3 PLCS (0.51) .500 options refer to SDP8004/8014 and SDP8304/8314. .045(1.14) MIN ~ ~ ~ ~ (12.71) .025(.64) GND Vo Vcc ~ ~ ~ ~ Device Polarity: Buffer - Output is HI when incident light intensity is .075 above the turnon threshold level. (1.91) 0.150 Inverter - Output is LO when incident light intensity is (3.81) above the turnon threshold level. DIM 026.ds4 Honeywell reserves the right to make changes in order to improve design and 192 h supply the best products possible.SDP8604/8614 Optoschmitt Detector 10 k Ohm Pull-Up Output ELECTRICAL CHARACTERISTICS PARAMETER SYMBOL MIN TYP MAX UNITS TEST CONDITIONS ABSOLUTE MAXIMUM RATINGS SCHEMATIC (25C Free-Air Temperature unless otherwise noted) Supply Voltage 12 V Duration of Output Short to V or Ground 1.0 sec Low Level Output Current 16.0 mA Irradiance 25 mW/cm Operating Temperature Range -40C to 85C Storage Temperature Range -40C to 85C Soldering Temperature (5 sec) 240C Notes 1. Derate linearly from 25C to 5.5 V at 85C. Honeywell reserves the right to make changes in order to improve design and 193 h supply the best products possible.