Y Y E E A A R R G G U U DPS Series 120W AC/DC DIN Rail Power Supplies AC - DC DIN rail mountable 120W power supplies Compact design High efficiency up to 86% PFC function available Parallel function available (switch) Input voltage 115/230VAC auto select 3 Year warranty Specificaton Model DPS-1-120-24 Input Specifications Input Voltage 115/230VAC Rated input voltage 115/230VAC Output Wattage 120W Input voltage range 115V: 90 to 132VAC, 230V: 186 to 264VDC Output Voltage 24VDC (Other output voltages available on request) Rated input current 2.8/1.4A Output Current 5A Line frequency 47 to 63Hz Efficiency (min/typ) 84/86% Inrush current 24A 115VAC, 48A 230VAC General Specification PFC 0.7 230VAC Isolation voltage 3000VAC Output Specifications Isolation resistance 100M 500VDC Output voltage accuracy 0 to 1% (adjusted pre-shipment) Ambient temperature -10 to +71C Minimum load 0% Derating (from 61 to 71C) 2.5%/C Line regulation 0.5% Storage temperature -25 to +85C Load regulation 1% single mode, 5% parallel mode Relative humidity 20 to 95% RH Hold up time 25mS 115VAC, 30mS 230VAC Cooling Free air convection Temperature coefficient 0.3%/C Dimensions L123.6 x W63.2 x D123.6 mm Ripple & noise 50mV Weight 920g Voltage trim range 22.5 to 28.5VDC Case material Metal DC ON indicator threshold at start up 17.6 to 19.4VDC DC LO indicator threshold after start up 17.6 to 19.4VDC Parallel operation up to 3 units Control and Protection Input fuse T3.15A/250VAC internal Rated over load protection 110 to 145% Power Rdy (24V model only) Electrical isolation: 500VDC Threshold volt. contact closed (start up): 17.6 to 19.4VDC Contact rating: 0.3A 60VDC Over voltage protection 125 to 145% Output short circuit Current limited Approvals and Standards CE, UL/cUL DPS-1-120/11/08 www.imopc.com A A R R A A N N T T E E E EL N DPS Series 120W 63.2 AC/DC DIN Rail Power Supplies 7 9 Dimensions (mm) Pin connections 116.6 7.0 Key Description 6 1 Rdy(1,2) DC ON output for relay (24V models only) + (3) Positive output terminal Fuse L Vo+ Inrush Current - - Rdy ++ S Limiter, Rectifier PFC Smoothing Switching + (4) Positive output terminal Rectifier Filter P and Auto Select Circuit Circuit Device Current - (5) Negative output terminal Vout adj. 115/230VAC N Vo- Detection DC LO - (6) Negative output terminal DC ON Single/Parallel Y PWM (7) Ground terminal to minimize high-frequency emissions Select Controller Opto- Reference & L (8) Input terminals (phase conductor, no polarity at DC input) Isolation Error Amp. Vout adj. N (9) Input terminals (neutral conductor, no polarity at DC input) DC ON Operation indicator LED Opto- Over Voltage DC LO DC low voltage indicator LED L Isolation Detection N Vout adj. Trimmer-potentiometer for Vout adjustment DC ON (Green LED) Output Level S/P Single/Parallel select switch 63.2 Detection DC LO (Red LED) 7 9 RDY (Relay Contact)* Installation Construction *24V models only Ventilation/Cooling Easy, safe and secure Normal convection snap-on, snap-off Derating All sides 25mm free space DIN-Rail mounting 116.6 7.0 for cooling recommended (TS35/7.5 or TS35/15) 6 1 Screw Terminal 10-24AWG flexible/solid cable Vo+ Inrush Current 100 - -++ Rdy S Strip cable ends by 8mm PFC Smoothing Limiter, Rectifier Switching Rectifier P and Auto Select Circuit Circuit Device Current Vout adj. 115/230VAC DC LO Vo- Detection 75 DC ON Single/Parallel PWM Select Controller Reference & Opto- Error Amp. Isolation Vout adj. Over Voltage Opto- L N Detection Isolation DC ON (Green LED) Output Level 63.2 0 Detection DC LO (Red LED) -10 61 71 7 9 Temperature (C) RDY (Relay Contact)* Connections Fuse L Vo+ Inrush Current PFC Smoothing Limiter, Rectifier Switching Rectifier Filter and Auto Select Circuit Circuit Device Current 115/230VAC N Vo- Detection Single/Parallel Y PWM Select Controller Opto- Reference & Isolation Error Amp. Vout adj. Opto- Over Voltage Isolation Detection DC ON (Green LED) Output Level Detection DC LO (Red LED) 61 71 RDY (Relay Contact)* Temperature (C) *24V models only DPS-1-120/11/09 www.imopc.com Power out (%) 123.6 123.6 123.6