Y Y E E A A R R G G U U DPS Series 480W AC/DC DIN Rail Power Supplies AC - DC DIN rail mountable 480W power supplies z Compact design z High efficiency up to 89% z PFC function available z Parallel function available (switch) z Universal input voltage z 3 Year warranty Specificaton Model DPS-1-240-24 Input Specifications Input Voltage 90~264VAC Rated input voltage 115/230VAC Output Wattage 480W Input voltage range 90 to 264VAC (230VAC typ.), 120 to 370VDC Output Voltage 24VDC Rated input current 7A 115VAC, 3.5A 230VAC Output Current 20A Line frequency 47 to 63Hz Efficiency (min/typ) 86/89% Inrush current 25A 115VAC, 50A 230VAC General Specification PFC 0.99 230VAC Isolation voltage 3000VAC Output Specifications Isolation resistance 100M 500VDC Output voltage accuracy 0 to 1% (adjusted pre-shipment) Ambient temperature -25 to +71C Minimum load 0% Derating (from 56 to 71C) 2.5%/C Line regulation 0.5% Storage temperature -25 to +85C Load regulation 0.5% single mode, 5% parallel mode Relative humidity 20 to 95% RH Hold up time 30mS Cooling Free air convection Temperature coefficient 0.02%/C Dimensions L125 x W175 x D123 mm Ripple & noise 100mV Weight 1920g Voltage trim range 22.5 to 28.5VDC Case material Metal DC ON indicator threshold at start up 17.6 to 19.4VDC DC LO indicator threshold after start up 17.6 to 19.4VDC Parallel operation up to 3 units Control and Protection Input fuse 10A/250VAC internal Rated over load protection 120 to 140% Power Rdy Electrical isolation: 500VDC Threshold volt. contact closed (start up): 17.6 to 19.4VDC Contact rating: 0.3A 60VDC Over voltage protection 30 to 33V Output short circuit Continuous current limited Approvals and Standards CE, UL/cUL DPS-1-480/07/07 www.imopc.com A A R R A A N N T T E E E E116 7.0 DC ON DC LO Rdy - - N L ++ P S DPS Series 480W Vout adj. 7 9 1 6 AC/DC DIN Rail Power Supplies 175 Dimensions (mm) Pin connections 116 7.0 Key Description Rdy(1,2)D C ON output for relay (24V models only) Fuse L Vo+ + (3) Positive output terminal Bridge Active PFC Switching Rectifier Filter Filter Rectifier Circuit Device Current + (4) Positive output terminal N Vo- Detection - (5) Negative output terminal Single/Parallel Y PWM - (6) Negative output terminal Select Controller Opto- Reference & ( 7) Ground terminal to minimize Isolation Error Amp. high-frequency emissions Vout adj. N ( 8) Input terminals (neutral conductor, DC ON DC LO Rdy N L ++- - Opto- Over Voltage no polarity at DC input) P Isolation Detection S L (9) Input terminals (phase conductor, Vout adj. 7 9 no polarity at DC input) 1 6 DC ON (Green LED) Output Level DC ON Operation indicator LED 175 Detection DC LO (Red LED) DC LO DC low voltage indicator LED RDY (Relay Contact)* Vout adj. Trimmer-potentiometer *24V models only for Vout adjustment S/P Single/Parallel select switch Derating 116.6 7.0 Installation 6 1 Fuse L Vo+ Ventilation/Cooling Bridge Active PFC Switching Normal convection 100 Rectifier Filter - -++ Rdy Rectifier Filter S Circuit Device Current All sides 25mm free space P N Detection Vo- for cooling recommended Vout adj. DC LO Single/Parallel Y PWM DC ON Screw Terminal Select Controller Opto- Reference & 62.5 10-24AWG flexible/solid cable Isolation Error Amp. Strip cable ends by 8mm Vout adj. Over Voltage Opto- Detection Construction Isolation L N Easy, safe and secure DC ON (Green LED) Output Level snap-on, snap-off Detection DC LO (Red LED) DIN-Rail mounting 63.2 0 (TS35/7.5 or TS35/15) RDY (Relay Contact)* -25 56 71 7 9 Temperature (C) *24V models only Connections 100 Fuse L Vo+ Inrush Current PFC Smoothing Limiter, Rectifier Switching Rectifier Filter and Auto Select Circuit Circuit Device Current 115/230VAC N Vo- Detection 62.5 Single/Parallel Y PWM Select Controller Opto- Reference & Isolation Error Amp. Vout adj. Opto- Over Voltage Isolation Detection DC ON (Green LED) 0 Output Level -25 56 71 Detection DC LO (Red LED) Temperature (C) RDY (Relay Contact)* *24V models only DPS-1-480/07/07 www.imopc.com 100 75 0 -25 61 71 Temperature (C) Power out (%) Power out (%) Power out (%) 125 123.6 125