82634CRAPRTFC Intel

Thank you for purchasing the Intel Aero Ready to Fly Drone The Intel Aero Ready to Fly Drone is a pre-assembled quadcopter that is purposely built for professional drone application developers to enable you to get your applications airborne quickly. This development platform is intended to be modified by developers according to their professional judgment. Intel has not established operating limitations for the kit or tested any configurations other than the base configuration that is shipped as configured from the factory. Developers are responsible for testing and ensuring the safety of their own configurations, and establishing the operating limits of those configurations. You should already have experience flying aircrafts via remote control using Manual flight mode which requires control of the drone with a two-gimbal joystick controller similar to the one included with the Intel Aero Ready to Fly Drone. Box Contents: This Getting Started Guide Terms & Conditions of Use and Important Safety Information Instruction manual for Spektrum DXe Transmitter Pre-assembled quad-copter airframe** 2 sets of snap-on propellers: A (x4) and B (x4) Spektrum* DXe Transmitter (2.4GHz DSMX*) 4 AA alkaline batteries for Spektrum DXe Transmitter **Battery not included. Recommended Battery: Li-Po, 4000 - 4500 mAh, 4S, with XT60 connector. Safety for the Battery: The Operator is responsible for obtaining a battery and battery charger which are certified for use in the Operators country of operation. The Operator is responsible for proper use of the battery and battery charger per the manufacturers safety guidelines. Getting Started 1. Read the Terms & Conditions of Use and Important Safety Information document (included in the box) before operating the drone. 2. Experienced pilots can begin flying immediately after following these steps: a. Attach a Battery i. Insert a battery inside the center cavity of the drones airframe with cables extending out toward the rear of the drone as shown in Figure 1. ii. Tighten the restraining strap around the battery to secure the battery as close to the center of the airframe as possible. iii. Connect the battery cable to the drone using the XT60 connector Figure 1. Intel Aero Ready to Fly Drone 1 b. Set up the GPS Antenna (see Figure 2) o i. Raise the GPS antenna mast 90 until vertical then tighten the antenna base cover Figure 2. Raising the GPS Antenna Mast c. Attach the propellers (see Figure 3 ) i. Identify propellers marked as A and B on top of the propeller blade. ii. Attach each propeller to its corresponding labeled motor by pressing down and twisting counter- clockwise (for A propellers) and clockwise (for B propellers) until each propeller latches securely. iii. To detach the propeller, press the center hub of the propeller while twisting the propeller blade in the opposite direction used when attaching. Figure 3. Propeller Identification 2