DrivingtheLightingRevolution Programmable CSIM CDD-CNPN Rev. B Features Programmable Dimming Control 0-10V dimming voltage output Programmable Soft Start Output Lumen Compensation Thermal Protection Daylight Harvesting Remote Control Programmable via PC interface Description This is a programmable Control Signal Integrating Module (CSIM). This module is designed to integrate multiple signals (Dimmer, Occupancy Sensor, Ambient Light Sensor, RNTC, Remote control, Output Lumen Compensation, etc) into a 0-10V analog output and a 5V PWM output. The internal parameters can be programmed by user via PC interface and programmer. Models P/N(1) Description CDD-CNPN Programmable CSIM with Default setting CDD-CNPNP CSIM Programmer Note: (1) A suffix xxxx may be added to denote variations or modifications to the base product, where x can be any alphanumeric character or blank Pin Configurations 16 DIM+ 15 Return 14 PWM OUT DH 1 13 SW Return 2 12 5V Supply RNTC 3 11 RC Return 4 10 TX 0-10V In 5 /PWM In 9 RX OS 6 Return 7 Vaux 8 Specifications are subject to changes without notice. www.inventronics-co.com Tel: 86-571-56565800 Fax: 86-571-86601139 sales inventronics-co.com DrivingtheLightingRevolution Programmable CSIM CDD-CNPN Rev. B Pin Description Wire Input Name Function number /Output 1 DH Input Daylight Harvesting Sensor to this pin 2,4,7,15 Return Return for auxiliary power and signal 3 RNTC Input Temperature protection, connect a RNTC from this pin to GND 0-10V In 5 Input 0-10V analog dimming signal input or PWM dimming signal input /PWM In 6 OS Input Occupancy Sensor, connect the sensor output to this pin 8 Vaux Input Auxiliary power supply for this controller 9 RX Input Programming interface-Receive 10 TX Output Programming interface-Transmit 11 RC Input Remote Control, connect the receiver to this pin 12 5V Supply Input/Output 5V input for programming/5V auxiliary output 13 SW Output System disable Output 14 PWM out Output PWM output for dimming 16 DIM+ Output Provide 0-10V dimming control signal NoteThe reference of all signals is Return. Function of 5-bit Jumper JP1 JP1 Default Setting Short Open Enable PWM Dimming Enable 0-10V Dimming Bit 1 (0-10V dimming is disabled) (PWM dimming is disabled) Disable Lumen Compensation and clear Bit 2 Enable Lumen Compensation working Time Open Bit 3 Set maximum output level, see application for details Bit 4 Bit 5 Enable Timing Profile Disable Timing Profile Specifications are subject to changes without notice. www.inventronics-co.com Tel: 86-571-56565800 Fax: 86-571-86601139 sales inventronics-co.com