DrivingtheLightingRevolution WDS-ADFNx Rev. C Features Convert DALI signal to 0-10V dimming signal Comply with DALI protocol DALI slave IP67 On/Off control with internal switch Description The DALI controller can convert DALI command to control the LED lamps current via LED drivers 0-10V interface, turn on or off LED lamp via internal switch. It complies with DALI protocol IEC62386-101,102,207. Typical application is shown as below: Implementation 1: LED Driver with Vaux Implementation 2: LED Driver without Vaux Model: P/N Suitable Output Voltage Range of LED Driver Max Note (1) (No-load Voltage Included) Input Current 0~80V Only for Two-Stage WDS-ADFN0 5A 25~80V Only for Single-Stage WDS-ADFN1 80~250V 2A WDS-ADFN2 250~500V 2A 0~80V Only for Two-Stage WDS-ADFN3 5A 25~80V Only for Single-Stage WDS-ADFN4 80~250V 2A WDS-ADFN5 250~500V 2A Note: (1) A suffix xxxx may be added to denote variations or modifications to the base product, where x can be any alphanumeric character or blank Interface Specifications Parameter Min. Typ. Max. Notes DA1,DA2 High Level 9.5V 16V 22.5V DA1,DA2 Low Level -6.5V 0V 6.5V DA1,DA2 Current 0mA - 2mA Note: All specifications are typical at 25 C unless otherwise stated. 1 / 9 Specifications are subject to changes without notice. www.inventronics-co.com Tel: 86-571-56565800 Fax: 86-571-86601139 sales inventronics-co.com DrivingtheLightingRevolution WDS-ADFNx Rev. C Auxiliary Input Specifications Parameter Min. Typ. Max. Notes Vaux Voltage 10V - 16V Vaux Current - - 20mA Dimming Output Specifications Parameter Min. Typ. Max. Notes Dim+ Voltage Max 9.5V - 10V Dim+ Voltage Min - - 1V Dim+ Sourcing Current 0mA - 10mA Dim+ Sink Current 0mA - 10mA Note: All specifications are typical at 25 C unless otherwise stated. Output Dimming Curve This controller integrates two curves, one is logarithmic curve and another is linear curve. Customer can select one curve in application. The default setting in factory is logarithmic curve, Customer can change logarithmic curve to linear curve by sending DALI command 227 (207 part). General Specifications Parameter Min. Typ. Max. Notes 300,000 Measured at 80%Load and 25C ambient MTBF - - Hours temperature (MIL-HDBK-217F) Dimensions Inches (L W H) 2.89 1.67 1.34 Millimeters (L W H) 74 42.4 34 Net Weight - 240 g - Note: All specifications are typical at 25 C unless otherwise stated. 2 / 9 Specifications are subject to changes without notice. www.inventronics-co.com Tel: 86-571-56565800 Fax: 86-571-86601139 sales inventronics-co.com