VANDAL RESISTANT SERIES 76-59 FEATURES TECHNICAL Vandal resistant MECHANICAL Panel sealed to IP67 Operating force 3N (typical) Panel thickness 1,5 mm to 8 mm Non rotating button Body Diameter M19 thread Machined from stainless steel Panel cut out 19,25 mm Wide temperature range of Life (min) 1,000,000 cycles 30C to + 105C Travel 2.3 mm Gold contacts Solder terminals ELECTRICAL Dielectric strength 1KV AC 1 minute NON-STANDARD OPTIONS Insulation resistance 1G 500V d.c Contact PCB terminals resistance (initial) 50m Illumination Electrical load Current rating, typical 32 VAC resistive: 400mA Engraving 50 VDC resistive: 100mA Tailored to suit your 125 VAC resistive: 125mA requirements Life 500,000 cycles (max load) 70C The 76-59 Series of push-button switches are extremely rugged making ENVIRONMENTAL AND PHYSICAL them particularly suited to applications in which vandal resistance is a necessity. Ingress protection IP67 (Panel Sealing) Operating temperature The switch body and buttons are range -30C to + 105C machined from hard-wearing stainless Body material Stainless steel steel and come in a front mounting style. SERIES 76-59 Actuator material Stainless steel The 76-59 Series all provide momentary Contact material Gold plated, nickel action and are based on our proven Terminal material Brass, 5m bright acid Series 59 push buttons. Connections are tin plate, nickel flash made via the solder terminal at the rear undercoat. of the switch. APPLICATIONS Vandal resistant and robust industrial requirements Flush-with-panel installation requirement Process control Railway carriage equipment External security door controls Elevators Fishing vessels Crane gantry equipment Earth moving equipment Upper deck yachting equipment Medical instrumentationORDERING BUTTON STYLE Flush - 1 MOUNTING Front panel 15 mm button 0 LED COLOUR Red R Green G Blue B (This digit only required for illuminated part numbers) PANEL MOUNTING AND CONSTRUCTION INFORMATION The 76-59 series mounts from the front into a CIRCUIT FORM 19,25 mm diameter panel cut out. Panel sealing is achieved by means of a sealer washer which is fitted to the switch body before it is inserted into the panel hole. The switch is then held in place by a lock-nut screwed on from the rear. PANEL MOUNTING DIAGRAMS 21.50 2.00 Body 8.60 14.80 Button 17.50 21.50 2.00 Body 8.60 14.80 Button SERIES 76-59 27.00 INGRESS PROTECTION IMPACT KEY IP67 Ingress Protection 6 totally protected 7protected 5kg against dust against the effects 40cm of immersion up to 1m 1m Impact 8J FURTHER INFORMATION ITW Switches A Division of ITW Limited e-mail: Norway Road, Portsmouth, info itwswitches.co.uk England PO3 5HT website: Tel: 00 44 (0) 2392 656200 Fax: 00 44 (0) 2392 666352 www.itwswitches.co.uk