DATA SHEE T N9320B RF Spectrum Analyzer 9 kHz to 3.0 GHzDefinitions and Conditions Specifications describe the performance of parameters covered by the product The spectrum analyzer will warranty and apply to the full temperature range of 5 to 45 C, unless otherwise noted. meet its specifications when: Typical values describe additional product performance information that is not covered It is within its calibration cycle It has been turned on at least 30 by the product warranty. It is performance beyond specifications that 80 percent of the minutes. It has been stored at an units exhibit with a 95 percent confidence level over the temperature range 20 to 30 C. ambient temperature within the Typical performance does not include measurement uncertainty. allowed operating range for at least two hours before being turned on Nominal values indicate expected performance, or describe product performance that if it has been stored previously at a temperature range inside the is useful in the application of the product, but are not covered by the product warranty. allowed storage range, but outside the allowed operating range. Frequency and Time Specification Supplemental Information Frequency Range 9 kHz to 3 GHz AC coupled 100 kHz to 3 GHz Preamp on Resolution 1 Hz Internal 10 MHz frequency reference Aging rate 1 ppm/year Temperature stability 1 ppm 5 to +45 C, reference 25 C Supply voltage stability 0.3 ppm Residual FM 100 Hz p-p in 100 ms nominal RBW = 1 kHz, VBW = 1 kHz Frequency readout accuracy (start, stop, center, marker) Marker resolution (freq span)/(number of sweep point -1) 1 Uncertainty (freq indication x freq reference uncertainty + 1% x span + 20% x resolution bandwidth + marker resolution) Sweep point 461, fixed Marker frequency counter Resolution 1 Hz, 10 Hz, 100 Hz, 1 kHz Selectable 1 Accuracy (marker freq x freq reference uncertainty ) + (counter resolution) Frequency span (FFT and swept mode) Range 0 Hz (zero span), 100 Hz to 3.0 GHz Resolution 1 Hz Accuracy span/(swept points -1) Sweep time and triggering Span range 10 ms to 1000 s Span > 0 Hz 6 s to 200 s Span = 0 Hz (minimum resolution = 6 s) Mode Continuous, single Trigger Free run, video, external Trigger slope Positive or negative edge Selectable Trigger delay 0 to 80 sweep time Resolution bandwidth (RBW) Range (3 dB bandwidth) 10 Hz to 1 MHz, in 1-3-10 sequence Accuracy 5% nominal Resolution filter shape factor < 5:1 nominal Range (6 dB bandwidth) 200 Hz, 9 kHz, 120 kHz, 1 MHz EMI bandwidth (CISPR 16-1-1 complaint), requires Option EMF Accuracy 10% nominal Resolution filter shape factor < 5:1 nominal 60 dB/6 dB bandwidth ratio Video bandwidth (VBW) Range 1 Hz to 1 MHz in 1-3-10 sequence 3 dB bandwidth 1. Frequency reference uncertainty = Aging rate x period since adjustment + supply voltage stability + temperature stability. Page 2 Find us at www.keysight.com