KCSC56-105 Kingbright

SURFACE MOUNT DISPLAY Part Number: KCSC56-105 Hyper Red Features Description z 0.56 inch digit height. The Hyper Red source color devices are made with Al- z Low current operation. GaInP on GaAs substrate Light Emitting Diode. z Excellent character appearance. z Mechanically rugged. z Gray face,white segment. z Package: 400pcs/ reel. z Moisture sensitivity level : level 2a. z RoHS compliant. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01 )unless otherwise noted. 2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. 3. The gap between the reflector and PCB shall not exceed 0.25mm SPEC NO: DSAG3012 REV NO: V.9A DATE: JUL/06/2016 PAGE: 1 OF 5 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1351000389 KingbrightSelection Guide Iv (ucd) 1 10mA Part No. Emitting Color (Material) Lens Type Description Min. Typ. 31000 80000 Common Cathode, Rt. KCSC56-105 Hyper Red (AlGaInP) White Diffused Hand Decimal. *14000 *29000 Note: 1. Luminous intensity/ luminous Flux: +/-15%. * Luminous intensity value is traceable to CIE127-2007 standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Emitting Color Typ. Max. Units Test Conditions peak Peak Wavelength Hyper Red 645 nm IF=10mA D 1 Dominant Wavelength Hyper Red 630 nm IF=10mA 1/2 Spectral Line Half-width Hyper Red 28 nm IF=10mA C Capacitance Hyper Red 35 pF VF=0V f=1MHz VF 2 Forward Voltage Hyper Red 1.85 2.5 V IF=10mA IR Reverse Current Hyper Red 10 uA VR=5V Notes: 1.Wavelength: +/-1nm. 2.Forward Voltage: +/-0.1V. 3.Wavelength value is traceable to CIE127-2007 standards. 4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter Values Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current 1 185 mA Reverse Voltage 5 V Operating / Storage Temperature -40C To +85C Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static electricity Ref JEDEC/JESD625-A and JEDEC/J-STD-033. SPEC NO: DSAG3012 REV NO: V.9A DATE: JUL/06/2016 PAGE: 2 OF 5 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1351000389 Kingbright