Memory Module Speci cations KVR16LE11/8HB 8GB 2Rx8 1G x 72-Bit PC3L-12800 CL11 240-Pin ECC DIMM DESCRIPTION SPECIFICATIONS ValueRAM s KVR16LE11/8 is a 1G x 72-bit (8GB) DDR3L-1600 CL(IDD) 11 cycles CL11 SDRAM (Synchronous DRAM) 2Rx8, ECC, low voltage, Row Cycle Time (tRCmin) 48.125ns(min.) memory module, based on eighteen 512M x 8-bit FBGA 260ns(min.) Refresh to Active/Refresh components. The SPD is programmed to JEDEC standard Command Time (tRFCmin) latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This Row Active Time (tRASmin) 35ns(min.) 240-pin DIMM uses gold contact fingers. The electrical and Maximum Operating Power 1.665 W* 1.35V mechanical specifications are as follows: UL Rating 94 V - 0 o o Operating Temperature 0 C to +85 C FEATURES o o Storage Temperature -55 C to +100 C JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply SDRAM SUPPORTED VDDQ = 1.35V (1.28V ~ 1.45V and 1.5V (1.425V ~ 1.575V) Hynix B-Die 8000MHz fCK for 1600Mb/sec/pin 8 independent internal banks Programmable CAS latency: 11, 10, 9, 8, 7, 6 Programmable Additive Latency: 0, CL - 2, or CL - 1 clock 8-bit pre-fetch Burst Length: 8 (interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4 which does not allow seamless read or write (either on the fly using A12 or MRS) Bi-directional Differential Data Strobe Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm 1%) On Die Termination using ODT pin On-DIMM thermal sensor (Grade B) Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C Asynchronous Reset PCB: Height 1.180 (30.00mm), double sided component Continued >> kingston.com Document No. VALUERAM1455-001.A00 11/25/14 Page 1MODULE DIMENSIONS kingston.com Document No. VALUERAM1455-001.A00 Page 2