254-05KP0B-RO Kobitone

Date: 09/11/07 Electret Condenser Microphone Dimensions: mm (in. ) Part Number: 4.8.10 254-05KP0B-RO (.189.004) .90.10 (.035.004) 2 2.5 (.098) 1 2.0.10 2.4 9.7.15 (.079.004) 5 1.5 (.095) (.38.006) (.197.059) 9.30 (.354.012) RL 1 +B IC OUT RL=1K (300~5K) 2 -B Ground Shield Case +20 +10 0 -10 -20 20 50 100 200 500 1K 2K 5K 10K 20K Frequency (Hz) KT-400299 Soldering Process: Electrical Specifications: Each condenser microphone contains a FET within its case. Sensitivity: -613dB (0dB=1V/1 bar 1 KHz) Generally, semiconductors are easily weakened by over- Output impedance: 1K heating, and over-charge of voltage. Frequency: 50Hz~16KHz Special caution is needed for proper soldering as follows: Standard voltage: 4.5V 500A 1. Use 30W (or under) soldering iron and maintain Current drain: max. 230-260C in operation. S/N ratio: 60dB or more 2. Soldering should be accomplished within two seconds at Maximum input sound pressure: 104dB SPL each terminal so as not to be overheated. Mechanical Specifications: 3. Do not make a cavity at the surface of lead on the pattern Storage temperature: -20C to 60C plate. (A cavity may change the characteristics of the mic.) Note: RoHS Compliant Available from Mouser Electronics www.mouser.com (800) 346-6873 Specifications are subject to change without notice. No liability or warranty implied by this information. Environmental compliance based on producer documentation. Electret Condenser Microphone SPL (dB)