Datasheet Single Mode Bluetooth Low Energy (BLE) Module Part BL600-SA, BL600-SC, BL600-ST, BL620-SA, BL620-SC, BL620-ST Version 3.8 Single Mode BLE Modules Datasheet REVISION HISTORY Ver. Date Notes Approver 1.0 16 Apr 13 Initial Release Jonathan Kaye 1.1 5 July13 Added: To Table 1, smartBASIC runtime engine FW upgrade via UART. To Table 1, smartBASIC application download via OTA. Section 3.3.4 OTA (Over-the-Air) smartBASIC Application Download Updated: Table 1 make it clear number of SPI (x1), I2C(x1) interfaces and ADC channels. Jonathan Kaye Table 2 (pin list), footnote mentions SIO 7 has Internal Pull down (default in FW). 5.2.1 Clocks section corrected 32.768 crystal accuracy to +/-20ppm. Added 16MHz crystal accuracy (+/-10ppm). 6.1 Circuit section circuit HW integration suggestion), on SIO 7 pin and Over the Air smartBASIC application download feature. Figure 14: BL600 Mechanical drawings BL600 Mechanical drawing to add measurements of the half-moon shaped positioning holes. 1.2 25 Oct 2013 Updated Recommended Operating Parameters notes to reflect 2.7 ms Jonathan Kaye rather than 2.7 s. 1.3 12 Dec 2013 Added baking schedule information. Jonathan Kaye 1.4 20 Dec 2013 Added: Jonathan Kaye ADC (AIN) input impedance into Table 6. AIN (ADC) impedance and external voltage divider setup into the 6.1 Circuit.section. 1.5 10 Jan 2014 Updated TOC with correct page numbers. Jonathan Kaye Added noted regarding smartBASIC firmwares lack of support for GPIO high drive state. 1.6 06 Feb 2014 Updated Bluetooth SIG Qualification section. Jonathan Kaye 1.7 18 Feb 2014 Updated Operating temperature range Jonathan Kaye Updated or added the following for the BL600-Sx-04: 1.8 04 April2014 Jonathan Kaye Lower power consumption figures (standby doze, deep sleep) and lower peripheral (UART, SPI, I2C, ADC) block currents for the BL600-Sx-04 (new Nordic silicon). Improved UART with deep RX buffer (6 bytes instead of 2 bytes). Increased the Absolute Max rating on the VCC pin from 3.6V to 3.9V. Added a note for External 12K resistor to GND on SWDCLK pin NOT required on BL600-Sx-04. Added the following for all BL600 module revisions to align with FW features: Section on PWM output and FREQ output signals. Note on GPIO high drive strength (5 mA). Note regarding internal DCDC convertor turned OFF on recommendation from chipset supplier until further notice. Embedded Wireless Solutions Support Center: 2 Americas: +1-800-492-2320