LEAPER-3D Leap

Standard Accessories Install software and driver LEAPER-3D FLASH WRITER main unit x1, USB cable x1, DC 12V/500mA adaptor x1, PC Software, drivers and manual on CD-ROM x1 1. Set Font Size to small fonts (96 dpi) to have the optimal display. 1.1 Click the right button on the desktop. -> Select the Properties at the bottom of the function menu. 1.2 Select Settings and then click the Advanced to set Font Size. 2. Install the software before connecting the Leaper-3D to the PC. 2.1 Insert the software CD into your CD-ROM drive. Normally the installation program will start automatically (if Auto Run is enabled for your CD-drive). Follow the instructions to complete installation. 2.2 If Auto Run doesn t work, click Setup.exe in the CD directory to start the installation. 3. Install the driver for the Leaper-3D hardware. 3.1 Make sure the Leaper-3D power is OFF . Connect the power adapter Adaptor USB cable Main unit to the Leaper-3D and a power outlet. 3.2 Connect the USB cable to PC and to the programmer USB port. 3.3 Turn the Leaper-3D power to ON . Windows will now start the Found Introduction New Hardware Wizard . 3.4 Install Hardware Device Driver -> Search for a suitable driver for my device (recommended) Unit top view 3.5 Select Optional search locations -> CD-ROM drives 3.6 Driver Files Search Result Unit back view -> Windows will find a driver for this device ... driver flashwriter.inf 3.7 Click Finish in the Found New Hardware Wizard Power switch USB port (B type) The Leaper-3D software and drivers have now been installed and the unit is ready for usage. IC package diagram Textool Textool handle DC 12V input socket 3.3 3.4 3.5 Caution 1. It is preferred to use an internal USB port of your PC. External USB LEAP Electronic Co., Ltd. Tel : + 886-2-2999 1860 ports are not recommended because of shared bandwidth Fax : + 886-2-2999 9873 and possible compatibility issues of other USB devices. http : //www.leap.com.tw Email: service leap.com.tw 3.6 3.7 Operation window Source file editing Programming source Load from PC Verify source IC 8bits HEX display 16bits HEX display Buffer & file information Save file Read from Exit program Edit file source IC Address of data Click and enter IC manufacturer, new address. type number HEX code Display Click to enter Device verify hexadecimal data. CheckSum ASCII code Display Click to enter text. Programming status Exit edit window Run Progress Stop bar Blank Protect / Erase Program Verify check security Confirm changes Program process & options Cancel changes Select IC number 8/16/32 Bits Set data block range by Get data block load file size Data block - checksum Move/Copy/Swap Data block - Fill Load file Save file Set data block Set data block range by maximum range by size of buffer selected IC size