Current transducer LF 510-S I = 500 A PN For the electronic measurement of current: DC, AC, pulsed..., with galvanic separation between the primary and the secondary circuit. Features Standards Bipolar and insulated current measurement up to 0.8 kA EN 50178: 1997 Current output UL 508:2010. Closed loop (compensated) current transducer Application Domain Panel mounting. Industrial. Advantages High accuracy Very low offset drift over temperature. Applications Windmill inverters Test and measurement AC variable speed and servo motor drives Statics converters for DC motors drives Battery supplied applications Uninterruptible Power Supplies (UPS) Switched Mode Power Supplies (SMPS) Power supplies for welding applications. Page 1/7 N97.J9.50.000.0 19November2015/Version 7 LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice www.lem.comLF 510-S Absolute maximum ratings Parameter Symbol Unit Value Maximum supply voltage (working) (40 85 C) U V 25.2 C Primary conductor temperature T C 100 B Maximum steady state primary current (40 85 C) I A 500 PN Stresses above these ratings may cause permanent damage. Exposure to absolute maximum ratings for extended periods may degrade reliability. UL 508: Ratings and assumptions of certification File E189713 Volume: 2 Section: 9 Standards USR indicates investigation to the Standard for Industrial Control Equipment UL 508. CNR indicates investigation to the Canadian standard for Industrial Control Equipment CSA C22.2 No. 14-13 Conditions of acceptability When installed in the end-use equipment, with primary feedthrough potential involved of 600 V AC/DC, consideration shall be given to the following: 1 - These products must be mounted in a suitable end-use enclosure. 2 - The secondary pin terminals have not been evaluated for field wiring. 3 - Low voltage control circuit shall be supplied by an isolating source (such as transformer, optical isolator, limiting impedance or electro-mechanical relay). 4 - Based on the temperature test performed on all Series, the primary bar or conductor shall not exceed 100 C in the end use application. Marking Only those products bearing the UL or UR Mark should be considered to be Listed or Recognized and covered under ULs Follow- Up Service. Always look for the Mark on the product. Page 2/7 19November2015/Version 7 LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice www.lem.com