B3104UCLRP Littelfuse

SIDACtor Protection Thyristors SLIC Protection Battrax Single Port Positive/Negative - MS-013 Description The Single Port Positive/Negative Battrax Series are programmable SIDACtor devices designed to protect SLICs (Subscriber Line Interface Circuit) from damaging overvoltage transients. This series is designed specically to protect SLIC devices utilizing positive and negative ringing signals. This one device will protect a single port. Features and Benets t Low voltage overshoot t Low Capacitance t Positive and negative t Low on-state voltage ringing compatible Agency Approvals t Does not degrade with t Single-port protect use Agency Agency File Number t Gate trgger tracking t Fails short circuit when device surged in excess of E133083 ratings Pinout Designation Applicable Global Standards t TIA-968-A t IEC 61000-4-5 1 6 t ITU K.20/21 Enhanced t YD/T 1082 2 5 Level t YD/T 993 t ITU K.20/21 Basic Level t YD/T 950 3 4 t GR 1089 Inter-building t GR 1089 Intra-building Schematic Symbol 6 (Ground) (T) 1 (-V ) 2 5 (+V ) REF REF (R) 3 4 (Ground) Electrical Characteristics V V V DRM S T I I I Capacitance* H S T l =5A 100V/s I =2.2 Amps Part Number Marking DRM T V min V max mA min mA max A max V max pF min pF max B3104UCLxx B3104UC IV 7* * * IV 7* * * 100 100 2.2 4 30 200 REF REF B3164UCLxx B3164UC IV 7* * * IV 7* * * 160 100 2.2 4 30 200 REF REF B3204UCLxx B3204UC IV 7* * * IV 7* * * 200 100 2.2 4 30 200 REF REF Notes: - V Max Value for the negative Battrax is -200 V. REF - Absolute maximum ratings measured at T = 25C (unless otherwise noted). - V 7 USBY JT BU F PS UIF QPTJUJW BMVF G 7 .BY A REF - Devices are bi-directional - XX = Part Number Sufx: TP (Tube Pack) or RP (Reel Pack). - All electrical characteristics shown are dened from Tip (pin 1) to Ground (pin 4 & 6) and * Off-state capacitance (C ) is measured across pins 1 & 4,6 and 3 & 4,6 O Ring (pin 3) to Ground (pin 4 & 6) at 1 MHz with a 2V bias. 2009 Littelfuse, Inc. 122 Specications are subject to change without notice. Please refer to www.littelfuse.com for current information. Battrax Single Port Pos/Neg SIDACtor Protection Thyristors SLIC Protection Surge Ratings I PP I TSM 1 1 1 1 1 1 1 1 1 di/dt 0.2x310 2x10 8x20 10x160 10x560 5x320 10x360 10x1000 5x310 50/60 Hz 2 2 2 2 2 2 2 2 2 0.5x700 2x10 1.2x50 10x160 10x560 9x720 10x360 10x1000 10x700 A min A min A min A min A min A min A min A min A min A min A/s max C 50 500 400 200 150 200 175 100 200 50 500 Notes: - Peak pulse current rating (I ) is repetitive and guaranteed for the life of the product. 1 Current waveform in s PP - I VSF SBOHF PG UP FS UFNQFSBU W SBUJOHT BQQMJDBCMF P * rating assumes V 7 FRVBMT 2 Voltage waveform in s PP PP REF - The device must initially be in thermal equilibrium with -40C < T < J Thermal Considerations Package Symbol Parameter Value Unit Modied MS-013 T Operating Junction Temperature Range UP C 6 J 5 4 T Storage Temperature Range UP C S 1 2 R Thermal Resistance: Junction to Ambient 60 C/W 0JA 3 V-I Characteristics t x t Pulse Waveform r d +I I PP V S t = rise time to peak value r V t = decay time to half value DRM d Peak 100 I H Value V REF V -V S REF I S Waveform = t x t r d V DRM V T I DRM 50 -V +V Half Value I DRM I H I S I T 0 t t r d 0 I PP t Time (s) -I Normalized V Change vs. Junction Temperature Normalized DC Holding Current vs. Case Temperature S 2.0 14 1.8 12 1.6 10 8 1.4 6 25C 1.2 25 C 4 1.0 2 0 0.8 -4 0.6 -6 0.4 -8 -40 -20 0 20 40 60 80 100 120 140 160 -40 -20 0 20 40 60 80 100 120 140 160 Case Temperature (T ) - C Junction Temperature (T ) C J C 2009 Littelfuse, Inc. 123 Specications are subject to change without notice. Please refer to www.littelfuse.com for current information. Series Percent of V Change % S I H I Peak Pulse Current %I PP PP Ratio of I (T = 25C) H C Battrax Single Port Pos/Neg