Thyristors Surface Mount 200V - 600V > MAC08BT1, MAC08MT1 Pb MAC08BT1, MAC08MT1 Description Designed for high volume, low cost, industrial and consumer applications such as motor control process control temperature, light and speed control. Features Sensitive Gate Trigger Current in Four Trigger Modes Blocking Voltage to 600 Volts Glass Passivated Surface for Reliability and Uniformity Surface Mount Package PbFree Packages are Available Functional Diagram Pin Out MT2 MT1 4 G Additional Information 1 2 3 Samples Datasheet Resources 2017 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 08/30/17Thyristors Surface Mount 200V - 600V > MAC08BT1, MAC08MT1 Maximum Ratings (T = 25C unless otherwise noted) J Rating Symbol Value Unit Peak Repetitive Off-State Voltage (Note 1) V , DRM (Gate Open, Sine Wave 50 to 60 Hz, T = -40 to 110C) J V V 200 MAC08BT1 RRM MAC08MT1 600 On-State RMS Current (Full Cycle Sine Wave, 60 Hz, T = 80C) I 0.8 A C T (RMS) Peak Non-Repetitive Surge Current I 8.0 A TSM (One Full Cycle Sine Wave, 60 Hz, T = 25C) C 2 Circuit Fusing Consideration (t = 8.3 msec) I t 0.4 Asec Peak Gate Power (Pulse Width 10 sec, T = 80C) P 5.0 W C GM Average Gate Power (t = 8.3 msec, T = 80C) P 0.1 W G(AV) C Operating Junction Temperature Range T -40 to +110 C J Storage Temperature Range T -40 to +150 C stg Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability. 1. V and V for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage however, positive gate voltage shall not be applied concurrent with negative DRM RRM potential on the anode. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. Thermal Characteristics Rating Symbol Value Unit R Thermal Resistance, JunctiontoAmbient PCB Mounted per Figure 1 8JA 156 C/W 2. These ratings are applicable when surface mounted on the minimum pad sizes recommended. 3. 1/8 from case for 10 seconds. 2017 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 08/30/17