PP-FP0088 LULZBOT

Taz 6 Enclosure This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License. Created by David Randolph and printedsolid.com Taz 6 Enclosure 2017 Version 2.1 Page 1 of 12 Whats Included 2 Part A: Front and rear panel 1 Part M: Front Middle 2 Part B: Top mount with holes 1 Part N: Front Shelf 1 Part C: Rear Left Stiffener 1 Part O: Front Bottom 2 Part D: Front Stiffener 1 Part P: Spool Top 2 Part E: Top Stiffener 1 Part Q: Machine Side 1 Part F: Rear Middle 1 Part R: Rear Right Stiffener 1 Part G: Rear Shelf 1 Part S: Spool Top Support 1 Part H: Rear Bottom 70 M3-10mm bolts 1 Part I: Rear Right 70 M3 square nuts 1 Part J: Rear Left 4 M4-8mm bolts 1 Part K: Front Left 4 M4 square nuts 1 Part L: Front Right 8 M5-20mm bolts Tools Needed 3mm hex driver 4mm hex driver Optional: Painters tape Optional: Flat razor Optional: Zip Tie Time Required 2-3 hours based on skill level WARNINGS Do not over tighten the screws in the hood. Tighten them just enough to hold without moving around. You can crack the acrylic very easily by over tightening. If you do crack a panel please contact printedsolid.com for replacements at a discounted rate. The enclosure is made from extruded acrylic for optical clarity that helps reduce visual distortions. Do not use household cleaners to clean the Acrylic. Use dish soap or hand wash and do not scrub or use any abrasives. Taz 6 Enclosure 2017 Version 2.1 Page 2 of 12