45W PWM Output LED Driver IDLV-45 series F M M S E L V F e a t u r e s A p p l i c a t i o n s C o n s t a n t V o l t a g e P W M s t y l e o u t p u t L E D s t r i p l i g h t i n g w i t h f r e q u e n c y 1 K H z I n d o o r L E D l i g h t i n g P l a s t i c h o u s i n g w i t h c l a s s I I d e s i g n L E D d e c o r a t i v e l i g h t i n g B u i l t - i n a c t i v e P F C f u n c t i o n L E D a r c h i t e c t u r e l i g h t i n g N o l o a d p o w e r c o n s u m p t i o n < 0 . 5 W ( B l a n k - T y p e ) F u n c t i o n o p t i o n s : 2 i n 1 d i m m i n g ( d i m - t o - o f f ) A u x i l i a r y D C o u t p u t 3 y e a r s w a r r a n t y D e s c r i p t i o n I D L V - 4 5 s e r i e s i s a 4 5 W A C / D C L E D d r i v e r f e a t u r i n g t h e c o n s t a n t v o l t a g e m o d e P W M s t y l e o u t p u t d e s i g n . I D L V - 4 5 o p e r a t e s f r o m 9 0 2 9 5 V A C a n d o f f e r s m o d e l s w i t h d i f f e r e n t r a t e d v o l t a g e r a n g i n g b e t w e e n 1 2 V a n d 6 0 V . T h a n k s t o t h e h i g h e f f i c i e n c y u p t o 9 0 % , w i t h t h e f a n l e s s d e s i g n , t h e e n t i r e s e r i e s i s a b l e t o o p e r a t e f o r - 2 0 ~ + 8 5 c a s e t e m p e r a t u r e u n d e r f r e e a i r c o n v e c t i o n . I D L V - 4 5 i s e q u i p p e d w i t h v a r i o u s f u n c t i o n o p t i o n s , s u c h a s d i m m i n g m e t h o d o l o g i e s , s o a s t o p r o v i d e t h e d e s i g n f l e x i b i l i t y f o r L E D l i g h t i n g s y s t e m . M o d e l E n c o d i n g - 4 5 - 1 2 I D L V A R a t e d o u t p u t v o l t a g e ( 1 2 / 2 4 / 3 6 / 4 8 / 6 0 V ) F u n c t i o n o p t i o n s R a t e d w a t t a g e S e r i e s n a m e T y p e F u n c t i o n N o t e B l a n k 2 i n 1 d i m m i n g ( 0 ~ 1 0 V D C a n d 1 0 V P W M ) I n S t o c k A 2 i n 1 d i m m i n g a n d A u x i l i a r y D C o u t p u t I n S t o c k File Name:IDLV-45-SPEC 2017-07-2145W PWM Output LED Driver IDLV-45 series SPECIFICATION MODEL IDLV-45 -12 IDLV-45 -24 IDLV-45 -36 IDLV-45 -48 IDLV-45 -60 36V DC VOLTAGE 12V 24V 48V 60V 3.0A 1.88A 1.25A 0.94A 0.75A RATED CURRENT 36W 45.12W 45W 45.12W 45W RATED POWER 0~100% DIMMING RANGE OUTPUT VOLTAGE TOLERANCE 10% PWM FREQUENCY (Typ.) 1KHz(20%) SETUP TIME Note.3 500ms / 230VAC 1200ms/115VAC AUXILIARY DC OUTPUT Note.4 Nominal 12V(deviation 11.4~12.6) 50mA for A-Type only 90 ~ 295VAC 127 ~ 417VDC VOLTAGE RANGE Note.2 (Please refer toSTATIC CHARACTERISTI section) FREQUENCY RANGE 47 ~ 63Hz PF>0.95/115VAC, PF>0.92/230VAC, PF>0.9/277VAC full load POWER FACTOR (Typ.) (Please refer toPOWER FACTOR (PF) CHARACTERISTI section) THD< 20%( load60%/115VAC,230VAC load75%/277VAC) INPUT TOTAL HARMONIC DISTORTION (Please refer to TOTAL HARMONIC DISTORTION section) 88% 90% EFFICIENCY (Typ.) 84% 86% 88% AC CURRENT (Typ.) 0.6A / 115VAC 0.4A / 230VAC 0.3A / 277VAC INRUSH CURRENT(Typ.) COLD START 30A(twidth=150s measured at 50% Ipeak) at 230VAC Per NEMA 410 MAX. No. of PSUs on 16A 32 units (circuit breaker of type B) / 32 units (circuit breaker of type C) at 230VAC CIRCUIT BREAKER LEAKAGE CURRENT <0.75mA / 277VAC NO LOAD POWER CONSUMPTION <0.5W for Blank-Type, <1.2W for A-Type Shut down O/P voltage, re-power on to recovery SHORT CIRCUIT PROTECTION 105 ~ 115% OVER CURRENT Protection type : Hiccup mode, recovers automatically after fault condition is removed WORKING TEMP. Tcase=-20 ~ +85 (Please refer to OUTPUT LOAD vs TEMPERATURE section) MAX. CASE TEMP. Tcase=+85 20 ~ 90% RH non-condensing WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +80, 10 ~ 95% RH TEMP. COEFFICIENT 0.03%/ (0 ~ 40) VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes UL8750,CSA C22.2 NO.250.13-12 ENEC EN61347-1 & EN61347-2-13 independent, EN62384,GB19510.1,GB19510.14 approved SAFETY STANDARDS WITHSTAND VOLTAGE I/P-O/P:3.75KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P:100M Ohms / 500VDC / 25/ 70% RH EMC EMC EMISSION Compliance to EN55015, EN61000-3-2 Class C ( load60%) EN61000-3-3,GB17743,GB17625.1 EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11 EN61547, light industry level(surge immunity:Line-Line:1KV) MTBF 386.59Khrs min. MIL-HDBK-217F (25) OTHERS DIMENSION 120*75*25mm (L*W*H) 0.22Kg 54pcs/13Kg/ 0.93CUFT PACKING 1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25 of ambient temperature. NOTE 2. De-rating may be needed under low input voltages. Please refer to STATIC CHARACTERISTIC sections for details. 3. Length of set up time is measured at cold first start. Turning ON/OFF the driver may lead to increase of the set up time. 4. There is no design of short circuit protection for the Auxiliary DC output this function can not be used when dimming input terminals(DIM+,DIM-) are short circuit or when it is no load or short circuit at output(Vo+,Vo-). 5. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. File Name:IDLV-45-SPEC 2017-07-21