24FC64F-IP Microchip

24AA64F/24LC64F/24FC64F 2 64K I C Serial EEPROM with Quarter-Array Write-Protect Temperature Ranges: Device Selection Table - Industrial (I): -40C to +85C Part VCC Max. Clock Temp. - Automotive (E): -40C to +125C Number Range Frequency Ranges (1) Description: 24AA64F 1.7-5.5 400 kHz I 24LC64F 2.5-5.5 400 kHz I, E The Microchip Technology Inc. 24AA64F/24LC64F/ (2) 24FC64F (24XX64F*) is a 64 Kbit Electrically Erasable 24FC64F 1.7-5.5 1 MHz I PROM. The device is organized as a single block of Note 1: 100 kHz for VCC <2.5V. 8K x 8-bit memory with a 2-wire serial interface. Low- 2: 400 kHz for VCC <2.5V. voltage design permits operation down to 1.7V, with standby and read currents of only 1 A and 400 A, Features: respectively. It has been developed for advanced, low- power applications such as personal communications Single-Supply with Operation down to 1.7V for or data acquisition. The 24XX64F also has a page 24AA64F/24FC64F Devices, 2.5V for 24LC64F Devices write capability for up to 32 bytes of data. Functional address lines allow up to eight devices on the same Low-Power CMOS Technology: bus, for up to 512 Kbits address space. The 24XX64F - Read current 400 A, max. is available in the standard 8-pin PDIP, surface mount - Standby current 1 A, max. (I-temp) SOIC, TSSOP, TDFN and MSOP packages. The 2 2-Wire Serial Interface, I C Compatible 24XX64F is also available in the 5-lead SOT-23 Packages with Three Address Pins are package. Cascadable up to Eight Devices Block Diagram Schmitt Trigger Inputs for Noise Suppression HV Output Slope Control to Eliminate Ground Bounce A0 A1 A2WP Generator 100 kHz and 400 kHz Clock Compatibility 1 MHz Clock for FC Versions Page Write Time 5 ms, typical I/O Memory EEPROM Control Control XDEC Array Self-timed Erase/Write Cycle Logic Logic 32-Byte Page Write Buffer Page Hardware Write-Protect for 1/4 Array Latches (1800h-1FFFh) I/O SCL ESD Protection > 4,000V YDEC More than One Million Erase/Write Cycles SDA Data Retention > 200 Years VCC Factory Programming Available Sense Amp. VSS Packages include 8-Lead PDIP, SOIC, TSSOP, R/W Control MSOP, TDFN, 5-Lead SOT-23 Pb-Free and RoHS Compliant Package Types PDIP/MSOP/SOIC/TSSOP TDFN SOT-23 A0 1 8 VCC SCL 1 5 WP A0 1 VCC 8 7 WP A1 2 7 WP A1 2 VSS 2 6 SCL A2 3 A2 3 6 SCL VSS 4 5 SDA VCC SDA 34 VSS 4 5 SDA *24XX64F is used in this document as a generic part number for the 24AA64F/24LC64F/24FC64F devices. 2009-2012 Microchip Technology Inc. DS22154B-page 124AA64F/24LC64F/24FC64F 1.0 ELECTRICAL CHARACTERISTICS () Absolute Maximum Ratings VCC.............................................................................................................................................................................6.5V All inputs and outputs w.r.t. VSS ......................................................................................................... -0.3V to VCC +1.0V Storage temperature ...............................................................................................................................-65C to +150C Ambient temperature with power applied................................................................................................-40C to +125C ESD protection on all pins 4kV NOTICE: Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only and functional operation of the device at those or any other conditions above those indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for extended periods may affect device reliability. TABLE 1-1: DC CHARACTERISTICS Industrial (I): TA = -40C to +85C, VCC = +1.7V to +5.5V DC CHARACTERISTICS Automotive (E): TA = -40C to +125C, VCC = +2.5V to +5.5V Param. Sym. Characteristic Min. Typ. Max. Units Conditions No. A0, A1, A2, WP, SCL and SDA pins D1 VIH High-level input voltage 0.7 VCC V D2 VIL Low-level input voltage 0.3 VCC V VCC 2.5V 0.2 VCC V VCC 2.5V D3 VHYS Hysteresis of Schmitt 0.05 VCC V VCC 2.5V (Note 1) Trigger inputs (SDA, SCL pins) D4 VOL Low-level output voltage 0.40 V IOL = 3.0 mA VCC = 4.5V IOL = 2.1 mA VCC = 2.5V D5 ILI Input leakage current 1 AVIN = VSS or VCC D6 ILO Output leakage current 1 AVOUT = VSS or VCC D7 CIN, Pin capacitance 10 pFVCC = 5.0V (Note 1) COUT (all inputs/outputs) TA = 25C, FCLK = 1 MHz D8 ICC write Operating current 0.1 3 mAVCC = 5.5V, SCL = 400 kHz D9 ICC read 0.05 400 A CCS Standby current .01 1 A Industrial D10 I 5 A Automotive SDA = SCL = VCC A0, A1, A2, WP = VSS Note 1: This parameter is periodically sampled and not 100% tested. 2: Typical measurements taken at room temperature. DS22154B-page 2 2009-2012 Microchip Technology Inc.