24AA024/24LC024/24AA025/24LC025 2 2K I C Serial EEPROM Device Selection Table Description: Part VCC Max Temp. Write The Microchip Technology Inc. 24AA024/24LC024/ Number Range Clock Range Protect 24AA025/24LC025 is a 2 Kbit Serial Electrically (1) Erasable PROM with a voltage range of 1.7V to 5.5V. 24AA024 1.7V-5.5V 400 kHz IYes The device is organized as a single block of 256 x 8-bit (1) 24AA025 1.7V-5.5V 400 kHz INo memory with a 2-wire serial interface. Low current 24LC024 2.5V-5.5V 400 kHz I, E Yes design permits operation with typical standby and 24LC025 2.5V-5.5V 400 kHz I, E No active currents of only 1 A and 1 mA, respectively. The device has a page write capability for up to 16 Note 1: 100 kHz for VCC < 2.5V bytes of data. Functional address lines allow the connection of up to eight 24AA024/24LC024/ Features: 24AA025/24LC025 devices on the same bus for up to 16K bits of contiguous EEPROM memory. The device Single Supply with Operation from 1.7V to 5.5V is available in the standard 8-pin PDIP, 8-pin SOIC for 24AA024/24AA025 Devices, 2.5V for (3.90 mm), TSSOP, 2x3 DFN and TDFN and MSOP 24LC024/24LC025 Devices packages. The 24AA025/24LC025 is also available in Low-Power CMOS Technology: the 6-lead SOT-23 package. - Read current 1 mA, typical Package Types - Standby current 1 A, typical 2 C Compatible 2-Wire Serial Interface, I PDIP/SOIC/TSSOP/MSOP DFN/TDFN Cascadable up to Eight Devices A0 1 8 VCC A0 1 8 VCC Schmitt Trigger Inputs for Noise Suppression 7 WP A1 2 Output Slope Control to Eliminate Ground Bounce A1 2 7 WP 6 SCL A2 3 100 kHz and 400 kHz Clock Compatibility VSS A2 3 6 SCL 4 5 SDA Page Write Time 5 ms Maximum VSS 4 5 SDA Self-timed Erase/Write Cycle SOT-23 16-Byte Page Write Buffer SCL 6 VCC 1 Hardware Write-Protect on 24XX024 Devices ESD Protection >4,000V VSS 2 5 A0 More than 1 Million Erase/Write Cycles 4 3 A1 SDA Data Retention >200 years Note: WP pin is not internally connected on the Factory Programming Available 24XX025. Packages include 8-lead PDIP, SOIC, TSSOP, DFN, TDFN and MSOP Block Diagram 6-Lead SOT-23 Package, 24XX025 only A0 A1 A2 WP* HV Generator Pb-Free and RoHS Compliant Temperature Ranges: I/O Memory - Industrial (I): -40C to +85C Control Control EEPROM Logic - Automotive (E): -40C to +125C Logic XDEC Array SDA SCL Write-Protect VCC Circuitry YDEC VSS Sense Amp. R/W Control 2009 Microchip Technology Inc. DS21210N-page 124AA024/24LC024/24AA025/24LC025 1.0 ELECTRICAL CHARACTERISTICS () Absolute Maximum Ratings VCC.............................................................................................................................................................................6.5V All inputs and outputs w.r.t. VSS ......................................................................................................... -0.3V to VCC +1.0V Storage temperature ...............................................................................................................................-65C to +150C Ambient temperature with power applied................................................................................................-40C to +125C ESD protection on all pins .................................................................................................................................................... 4kV NOTICE: Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only and functional operation of the device at these or any other conditions above those indicated in the operation sections of the specifications is not implied. Exposure to Absolute Maximum Rating conditions for extended periods may affect device reliability. TABLE 1-1: DC SPECIFICATIONS Industrial (I): TA = -40C to +85C, VCC = +1.7V to +5.5V DC CHARACTERISTICS Automotive (E): TA = -40C to +125C, VCC = +2.5V to +5.5V Param. Symbol Characteristic Min. Typ. Max. Units Conditions No. A0, A1, A2, SCL, SDA and WP pins D1 VIH High-level input voltage 0.7 VCC V D2 VIL Low-level input voltage 0.3 VCC V0.2 VCC for VCC < 2.5V D3 VHYS Hysteresis of Schmitt 0.05 VCC V (Note) Trigger inputs D4 VOL Low-level output voltage 0.40 V IOL = 3.0 mA, VCC = 2.5V D5 ILI Input leakage current 1 AVIN = VSS or VCC D6 ILO Output leakage current 1 AVOUT = VSS or VCC D7 CIN, Pin capacitance 10 pFVCC = 5.5V (Note) COUT (all inputs/outputs) TA = 25C, FCLK = 1 MHz D8 ICC write Operating current 0.1 3 mA VCC = 5.5V, SCL = 400 kHz D9 ICC read 0.05 1 mA D10 ICCS Standby current 0.01 1 A Industrial 5 A Automotive SDA = SCL = VCC A0, A1, A2, WP = VSS Note: This parameter is periodically sampled and not 100% tested. DS21210N-page 2 2009 Microchip Technology Inc.