93AA76P Microchip

93AA76/86 93AA76/86 Not recommended for new designs Please use 93AA76C or 93AA86C. 93AA76/86 8K/16K 1.8V Microwire Serial EEPROM Features: Package Types Single supply operation down to 1.8V PDIP Package Low-power CMOS technology: - 1 mA active current typical -5 A standby current (typical) at 3.0V 8 CS 1 VCC ORG pin selectable memory configuration: 7 PE CLK 2 - 1024 x 8 or 512 x 16-bit organization 6 DI 3 ORG (93AA76) 5 4 DO VSS - 2048 x 8 or 1024 x 16-bit organization (93AA86) Self-timed erase and write cycles SOIC Package Automatic ERAL before WRAL Power on/off data protection circuitry 8 1 CS VCC Industry standard 3-wire serial I/O 7 2 CLK PE Device status signal during erase/write cycles 6 ORG 3 DI Sequential read function 5 VSS DO 4 1,000,000 erase/write cycles ensured Data retention > 200 years 8-pin PDIP/SOIC package Block Diagram Temperature ranges available: - Commercial (C): 0C to +70C VCC VSS Description: The Microchip Technology Inc. 93AA76/86 are 8K and Address Memory Decoder Array 16K low voltage serial Electrically Erasable PROMs. The device memory is configured as x8 or x16 bits depending on the ORG pin setup. Advanced CMOS technology makes these devices ideal for low power Address nonvolatile memory applications. These devices also Counter have a Program Enable (PE) pin to allow the user to write-protect the entire contents of the memory array. The 93AA76/86 is available in standard 8-pin PDIP and Data Output DO 8-pin surface mount SOIC packages. Register Buffer DI Mode Decode PE Logic CS Clock CLK Generator 2004 Microchip Technology Inc. DS21130E-page 193AA76/86 1.0 ELECTRICAL CHARACTERISTICS () Absolute Maximum Ratings VCC.............................................................................................................................................................................7.0V All inputs and outputs w.r.t. VSS ........................................................................................................-0.6V to Vcc + 1.0V Storage temperature ...............................................................................................................................-65C to +150C Ambient temperature with power applied................................................................................................-40C to +125C Soldering temperature of leads (10 seconds) .......................................................................................................+300C ESD protection on all pins..........................................................................................................................................4 kV NOTICE: Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational listings of this specification is not implied. Exposure to Absolute Maximum Rating conditions for extended periods may affect device reliability. 1.1 AC Test Conditions AC Waveform: VLO = 2.0V VHI = Vcc - 0.2V (Note 1) VHI = 4.0V for (Note 2) Timing Measurement Reference Level: Input 0.5 VCC Output 0.5 VCC Note 1: For VCC < 4.0V 2: For VCC > 4.0V DS21130E-page 2 2004 Microchip Technology Inc.