MCP1415T-E/OT Microchip

MCP1415/16 Tiny 1.5A, High-Speed Power MOSFET Driver Features General Description High Peak Output Current: 1.5A (typical) The MCP1415/16 devices are high-speed, dual MOSFET drivers that are capable of providing up to Wide Input Supply Voltage Operating Range: 1.5A of peak current while operating from a single 4.5V - 4.5V to 18V to 18V supply. The inverting or non-inverting single Low Shoot-Through/Cross-Conduction Current in channel output is directly controlled from either TTL or Output Stage CMOS (3V to 18V) logic. These devices also feature High Capacitive Load Drive Capability: low shoot-through current, matched rise and fall time, - 470 pF in 13 ns (typical) and short propagation delays which make them ideal for high switching frequency applications. They provide - 1000 pF in 18 ns (typical) low enough impedances in both the On and Off Short Delay Times: 44 ns (t ), 47 ns (MCP1415 D1 states to ensure the intended state of the MOSFET is t ), 54 ns (MCP1416 t ) (typical) D2 D2 not affected, even by large transients. Low Supply Current: These devices are highly latch-up resistant under any - With Logic 1 Input - 0.65 mA (typical) condition within their power and voltage ratings. They - With Logic 0 Input - 0.1 mA (typical) are not subject to damage when noise spiking (up to Latch-Up Protected: Withstands 500 mA Reverse 5V, of either polarity) occurs on the Ground pin. They Current can accept up to 500 mA of reverse current being Logic Input Withstands Negative Swing up to 5V forced back into their outputs without damage or logic Space-Saving 5L SOT-23 Package upset. All terminals are fully protected against electrostatic discharge (ESD) up to 2.0 kV (HBM) and 300V (MM). Applications Switch Mode Power Supplies Pulse Transformer Drive Line Drivers Level Translator Motor and Solenoid Drive Package Types SOT-23-5 MCP1415 MCP1416 NC NC 1 5 1 5 OUT OUT V 2 2 DD V DD IN 3 4 GND 3 4 GND IN MCP1415R MCP1416R 1 5 V NC 5 V NC 1 DD DD 2 2 GND GND IN 3 4 OUT IN 3 4 OUT 2008-2016 Microchip Technology Inc. DS20002092G-page 1MCP1415/16 Functional Block Diagram V DD Inverting 650 A 300 mV Output Non-inverting Input Effective 4.7V MCP1415 Inverting Input C = 25 pF MCP1416 Non-inverting (Each Input) GND Note: Unused inputs should be grounded. 2DS20002092G-page 2008-2016 Microchip Technology Inc.