MIC94065YMT-TR Microchip

MIC94064/5 High Side Power Switches General Description Features The MIC94064 and MIC94065 are high-side load 1.7V to 5.5V input voltage range switches designed for operation between 1.7V to 5.5V. 2A continuous operating current The devices contain a low on-resistance P-channel 77m (typ) R DSON MOSFET that supports over 2A of continuous current. Built-in level shift for control logic can be operated by The MIC94064/5 provides a slew rate controlled Soft- 1.5V logic. Start turn-on of 115s (typical) to prevent in-rush current Low 2A quiescent current from glitching supply rails. Soft-Start: 115s The MIC94065 features an active load discharge circuit Micro-power shutdown <1A which insures capacitive loads retain no charge when the main switch is in an OFF state. Load discharge circuit: MIC94065 An active pull-down on the enable input keeps Space saving 1.2x1.6 mm Thin MLF package MIC94064/5 in a default OFF state until the EN pin is pulled to a high level. Built-in level shift circuitry allows Applications low voltage logic signals to switch higher supply voltages, or vice versa high level logic signals can Load switch in portable applications: control low level voltages. - Cellular phones The MIC94064/5s operating voltage range makes them - PDAs suitable for 1-cell Lithium ion and 2- to 3-cell - MP3 players NiMH/NiCad/Alkaline powered systems, as well as all 5V - Digital Cameras applications. Their low operating current of 2A and low - Portable instrumentation shutdown current of <1A maximize battery life. Battery switch-over circuits Data sheets and support documentation can be found on Micrels web site at: www.micrel.com. Level translator Typical Application MIC94064 MIC94065 Load Switch Application Load Switch with Capacitive Load Discharge MLF and MicroLeadFrame are registered trademarks of Amkor Technologies, Inc. Micrel Inc. 2180 Fortune Drive San Jose, CA 95131 USA tel +1 (408) 944-0800 fax + 1 (408) 474-1000 Micrel, Inc. MIC94064/5 Ordering Information (1) Part Number Part Marking Soft-Start Load Discharge Package Standard Pb-Free Standard Pb-Free (1) MIC94064YC6 64P SC-70-6 (1) 6P5 MIC94065YC6 P64 MIC94064YMT 1.2mm x 1.6mm Thin MLF P65 MIC94065YMT Notes 1. Underbar symbol on SC-70 Pb-free packages may not be to scale. Pin Configuration SC-70-6 (C6) 1.2x1.6 mm Thin MLF (MT) Pin Description Pin Number Pin Name Pin Function SC-70 MLF 1 1 V Drain of P-channel MOSFET. OUT 2,5 2 GND Ground and the backside pad (MLF only) should both be connected to electrical ground. 4 3 V Source of P-channel MOSFET. IN Enable (Input): Active-high CMOS compatible control input for switch A. Do not leave 3 4 EN floating. No Internal Connection. A signal or voltage applied to this pin will have no effect on device 6 -- NIC operation. January 2008 2 M9999-011608