RN1810/RN1810E 2.4 GHz IEEE 802.11b/g/n Wireless Module Features IEEE 802.11b/g/n Compliant Transceiver 2.4 GHz IEEE 802.11n Single Stream 1x1 UART Interface to Host Controller (4-wire including RTS/CTS) Integrates Easily into Final Product - Minimizes Product Development, Provides Quicker Time to Market Configured using Simple ASCII Commands Fully Integrated Wireless Module with Voltage Regulation, Crystal, RF Matching Circuitry, Power Amplifier (PA), Low Noise Amplifier (LNA) and PCB Trace Antenna Ultra-Small W.FL Connector for External Antennas (RN1810E) Compact Surface Mount Module: 0.700 x 1.050 x 0.085 (17.8 mm x 26.7 mm x 2.2 mm) Compliance Castellated Surface Mount Pads for easy and Modular Certified for the United States (FCC) and reliable PCB mounting Canada (IC) Environmentally Friendly, RoHS Compliant European R&TTE Directive Assessed Radio Module Operational Australia, New Zealand, Korea, Taiwan and Japan Single Operating Voltage: 3.15V to 3.45V (3.3V typical) Applications Temperature Range: -40C to +85C Industrial Utility and Smart Energy Low-Current Consumption: Consumer Electronics - RX mode: 64 mA (typical) Industrial Controls - TX mode: 246 mA at 18 dBm (typical) Remote Device Management Power Saving Mode: Retail - Sleep: 12 A (typical) Medical, Fitness and Health Care RF/Analog Networking Frequency: 2.412 to 2.472 GHz Supports Infrastructure and SoftAp Networking Channels: 1-13 Modes Modulation: DSSS, CCK, BPSK, QPSK, 16QAM Built-In Networking Applications: IPv4/IPv6, TCP, and 64QAM UDP, DHCP, DNS, ICMP, ARP, HTTP, FTP, SNTP Sensitivity: -94 dBm and SSL/TLS Complete On-Board TCP/IP Networking Antenna Upgrade Firmware Over the Air using TFTP Integral PCB Trace Antenna (RN1810) Supports Wi-Fi Protected Setup (WPS) External Antenna (RN1810E) 2016-2021 Microchip Technology Inc. DS50002460C-page 1RN1810/RN1810E NOTES: DS50002460C-page 2 2016-2021 Microchip Technology Inc.