USB5537B 7-Port SS/HS USB Hub Controller Emulates portable/handheld native wall chargers General Description - Charging profiles emulate a handheld The USB5537B hub is a 7-port SuperSpeed/Hi-Speed, devices wall charger to enable fast charging low-power, configurable hub controller family fully com- (minutes vs. hours) pliant with the USB 3.0 Specification. The USB5537B Enables charging from a mobile platform that is supports 5Gbps SuperSpeed (SS), 480Mbps Hi- off Speed (HS), 12 Mbps Full-Speed (FS) and 1.5 Mbps Support tablets high current requirements Low-Speed (LS) USB signaling for complete coverage of all defined USB operating speeds. Optimized for low-power operation and low ther- mal dissipation The USB5537B supports USB 2.0 speeds through its Vendor Specific Messaging (VSM) support for USB 2.0 hub controller. The new SuperSpeed hub con- firmware upload over USB troller (available on 4 of the 7 ports) operates in parallel with the USB 2.0 controller, so the 5 Gbps SuperSpeed Configuration via OTP ROM, SPI ROM, or SMBus data transfers are not affected by the slower USB 2.0 On-chip 8051 C manages VBUS, and other hub traffic. signals The USB5537B supports battery charging on a per port 8 KB RAM, 32 KB ROM basis. On battery charging enabled ports, the devices One Time programmable (OTP) ROM: 8 kbit provide automatic USB data line handshaking. The - Includes on-chip charge pump handshaking supports USB 1.2 Charging Downstream Single 25 MHz XTAL or clock input for all on-chip Port (CDP), Dedicated Charging Port (DCP) and non- PLL and clocking requirements USB 1.2 devices. Supports JTAG boundary scan The USB5537B is configured for operation through PHYBoost (USB 2.0) internal default settings, where custom configurations - Selectable drive strength for improved signal are supported through an on-chip OTP ROM, an exter- integrity nal SPI ROM, or SMBus. VariSense (USB 2.0) - controls the receiver sensitivity enabling four Product Features programmable levels of USB signal receive USB 3.0 compliant 5 Gbps, 480 Mbps, 12 Mbps sensitivity and 1.5 Mbps operation, USB pins are 5 V toler- IETF RFC 4122 compliant 128-bit UUID ant - Integrated termination and pull-up/pull-down Software Features resistors Four downstream USB 3.0 ports Compatible with Microsoft Windows 7, Vista, XP, Mac OSX10.4+, and Linux Hub Drivers Three additional USB 2.0 ports for use cases where SS is not required Supports battery charging of most popular battery powered devices - USB-IF Battery Charging rev. 1.2 support (DCP & CDP) - Apple Portable product charger emulation - Blackberry charger emulation - Chinese YD/T 1591-2006 charger emulation - Chinese YD/T 1591-2009 charger emulation - Supports additional portable devices 2012 - 2014 Microchip Technology Inc. DS00001682B-page 1USB5537B TO OUR VALUED CUSTOMERS It is our intention to provide our valued customers with the best documentation possible to ensure successful use of your Microchip products. To this end, we will continue to improve our publications to better suit your needs. Our publications will be refined and enhanced as new volumes and updates are introduced. If you have any questions or comments regarding this publication, please contact the Marketing Communications Department via E-mail at docerrors microchip.com. We welcome your feedback. Most Current Data Sheet To obtain the most up-to-date version of this data sheet, please register at our Worldwide Web site at: