VSC7223 Multirate 16 Gbps Quad Adaptive Channel Extender with All-Rate CRU Microsemis advanced unidirectional lane adaptive channel extender Highlights equalizes deteriorated input signals while dissipating the lowest possible World-class adaptive equalization power. Wide retiming range from 155 Mbps to The VSC7223 device is a quad unidirectional lane adaptive channel 16Gbps extender with a CRU. It incorporates input equalization, clock and data 20 dB input equalization recovery, and output de-emphasis. It operates at data rates from 155 Retimer and re-driver modes Mbps to 16 Gbps. Built-in VScope The VSC7223 device is a simple-to-use copper media receiver and On-chip frequency synthesizers driver that provides electrical compensation to cable, copper, and backplane environments to increase system margin and media driving Applications distances. It equalizes greater than 65 inches of FR-4 at 10 Gbps and Wideband signal switching, clean-up, and greater than 15 meters of 24AWG of SFP+ copper direct-attached cable retimer at 10 Gbps. Line, backplane, and copper cable driver, The VSC7223 device can be used either on its own or with an external receiver, and retimer microcontroller to control, monitor, and enhance system performance. PCB signal enhancement The VSC7223 device uses advanced technology to equalize Optical module retimer and receiver deteriorated input signals while dissipating the lowest possible power. A low-cost 25 MHz crystal, along with an on-chip frequency synthesizer, allows for CRU operation at any data rate. Its three-tap FIR output driver architecture enables up to 20 dB of de-emphasis at 10 Gbps. The VSC7223 device includes Microsemis patented VScope input signal monitoring integrated circuit waveform viewing technology. The VSC7223 device is available in a compact 5 mm x 9 mm 48-pin QFN package. The device operates on a single supply of 1.2 volts. Box-to-Box Board-to-Board Driving Cables and Optics Driving Backplanes Processing Switch Card Traffic VSC7223 VSC7223 Management VSC7223 Switch ASIC ASIC Microsemi makes no warranty, representation, or guarantee regarding the information contained herein or the suitability of its products and services for any particular purpose, nor does Microsemi assume any liability whatsoever arising out of the application or use of any product or circuit. The products sold hereunder and any other products sold by Microsemi have been subject to limited testing and should not be used in conjunction with mission-critical equipment or applications. Any performance speci cations are believed to be reliable but are not veri ed, and Buyer must conduct and complete all performance and other testing of the products, alone and together with, or installed in, any end-products. Buyer shall not rely on any data and performance speci cations or parameters provided by Microsemi. It is the Buyers responsibility to independently determine suitability of any products and to test and verify the same. The information provided by Microsemi hereunder is provided as is, where is and with all faults, and the entire risk associated with such information is entirely with the Buyer. Microsemi does not grant, explicitly or implicitly, to any party any patent rights, licenses, or any other IP rights, whether with regard to such information itself or anything described by such information. Information provided in this document is proprietary to Microsemi, and Microsemi reserves the right to make any changes to the information in this document or to any products and services at any time without notice.VSC7223 Multirate 16 Gbps Quad Adaptive Channel Extender with All-Rate CRU Key Bene ts Key Speci cations Simple-to-use device 1.2 V single power supply Low module and system power consumption 180 mW per channel power consumption (retimer) Auto-adapts equalizer and DFE tap settings 110 mW per channel power consumption (re-driver) Wide range of data rate operation with 25 MHz crystal and 18 dB programmable output de-emphasis built-in frequency synthesizer Two-wire serial interface World-class adaptive equalization Compact 5 mm x 9 mm QFN package LOS detection Related Products Built-in VScope input signal monitoring integrated circuit eye diagram monitoring Visit www.microsemi.com for information about these related products: Architecture VSC3308 Two-wire serial port for optional microcontroller VSC3316 Pin-strap option for operation without microcontroller VSC7227 Four-tap decision feedback equalizer (DFE) Built-in diagnostics VScope OUTP0 INP0 Driver EQ OUTN0 INN0 DFE LOS LOS CDR CCAP0 REFCLK Channel 0 Channel 1 Channel 2 Channel 3 Digital Core XTALA/CLKINP Control Logic Frequency REFCLK Synthesizers XTALB/CLKINN Two-Wire Interface Microsemi Corporation (Nasdaq: MSCC) offers a comprehensive portfolio of semiconductor and system solutions for com- munications, defense and security, aerospace, and industrial markets. Products include high-performance and radiation- hardened analog mixed-signal integrated circuits, FPGAs, SoCs, and ASICs power management products timing and synchronization devices and precise time solutions voice processing devices RF solutions discrete components enter- prise storage and communications solutions, security technologies, and scalable anti-tamper products Ethernet solutions Power-over-Ethernet ICs and midspans custom design capabilities and services. Microsemi is headquartered in Aliso Viejo, California, and has approximately 4,800 employees worldwide. Learn more at www.microsemi.com. Microsemi Corporate Headquarters One Enterprise, Aliso Viejo, CA 92656 USA Within the USA: +1 (800) 713-4113 Outside the USA: +1 (949) 380-6100 20132016 Microsemi Corporation. All rights reserved. Microsemi and the Microsemi logo are registered trademarks of Microsemi Corporation. All other trademarks Sales: +1 (949) 380-6136 and service marks are the property of their respective owners. Fax: +1 (949) 215-4996 VPPD-03236. 1.0. 4/16 email: sales.support microsemi.com www.microsemi.com