2. Soldering the headers Before using your click board, make sure to solder 1x8 male headers to both left and right side of the board. Two 1x8 male headers are included with the board in the package. 1 nRF T click 2 3 1. Introduction 4. Essential features nRF T Click with its nRF24L01P IC is designed for operation in the world wide ISM frequency band at 2.400 - 2.4835 GHz. The board supports an air data rate of 250 Kbps, 1 Mbps and 2 Mbps and it is suitable for ultra Turn the board upside down so that Turn the board upward again. Make sure low power designs. All these features make bottom side is facing you upwards. Place to align the headers so that they are this board ideal for wireless PC peripherals, shorter parts of the header pins in both perpendicular to the board, then solder the remotes, VoIP headsets, game controllers, soldering pad locations. pins carefully. sensors, home and commercial automation, active RFID, toys and many more. nRF T Click is an add-on board in mikroBUS form factor. Its a compact and easy solution 3. Plugging the board in for adding 2.4 GHz transceiver to your design. click It features nRF24L01P 2.4 GHz transceiver Once you have soldered the headers your module with an embedded baseband protocol board is ready to be placed into desired BOARD engine as well as 2.4 GHz PCB trace antenna. mikroBUS socket. Make sure to align the www.mikroe.com nRF T Click communicates with target cut in the lower-right part of the board board microcontroller via mikroBUS SPI with the markings on the silkscreen at the nRF T click Manual (SDI, SDO, SCK, CS ), CE and INT lines. mikroBUS socket. If all of the pins are ver. 1.01 The board is designed to use 3.3V power aligned correctly, push the board all the way supply only. LED diode (Green) indicates into the socket. the presence of power supply. 0 100000 0222906. Trace or Chip antenna 5. nRF T Click Board Schematic If you need the board with SMD chip antenna, we recommend you to use other board such as nRF C Click: R3 22K